20 Most Recent 1995 Nissan Maxima - Page 8 Questions & Answers

it sounds like the windage tray underneath the engine is loose and needs to be buttoned back up. i recommend looking into it because in the case of a heavy rain, water could enter the engine bay easier and knock off the serpentine belt. and a disrepaired windage tray affects highway gas mileage.

I have this problem on my max as well i leave it running for a bit this solves my problem

red is normally power in and black is normally earth wire. Get a 12 volt dc transformer that plugs into the power outlet and get the plug jack socket from a electronic shop and solder the wires correctly (red to centre pole ) and it should work . You will need a high wattage transformer for this.

starter bad

sometimes no codes can be a failing crank sensor working not working.. fault will be logged but no codes will be stored i

My nissan runs really good but for some reason my battery keeps draining itself flat why?

sounds like short somewhere draining battery. Might be alternator causing this also. can have it checked at autozone at no cost....good luck and hope this info helps....Please rate this post.

Check the fuel pump fuse and wiring between fuse block and fuel pump.

That would be rare & doubtful if one spark plug ever fails in your lifetimeYou may have cylinder ignition misfires & you knowany vehicle issue has to be diagnosed at a repair shop

need a repair manual and rite tools--they doit with a special machine in shop and solvent--------try using some amsoil PI 1st----ur issue cud also be ignition components-inspect and test

Yes there is a fuse, the panal is under the dash on the left side of the steering wheel, fuse is marked, change it even if it looks good.

At what speed do you feel the shake and does it only happen when you apply the brakes?

Hola!

Si lo solucione el carro ya esta bien, le cambiaron el sensor crankshaft y le limpiaron el camshaft son dos sensores que estan en el motor, puedes encontrar mas informacion en internet poninedo la palabra crankshaft en el buscador, de cualquier manera te aseguro que eso va a solucionar el problmea, tambien le arreglaro la marcha despues de eso porque se barrio el engrane de tanto intentar encender el carro, pero ya no tengo ningun problema, espero puedas arreglar tu carro y cualquier otra cosa que necesites escribeme y si te puedo ayudar con gusto lo hare.

Saludos

Rocio

Start by replacing your Camshaft Position Sensor. It's located On the timing cover just above the belt tensioner.

Disconnect the negative battery terminal for thirty seconds or get a scan tool or go to an Autozone who usually will do it free of charge.

Here's a link to your timing chain.