20 Most Recent 1996 Oldsmobile Cutlass Supreme Coupe Questions & Answers

This has already been answered...Here's a copy
Open the car door and pull on the release latch that you use to open the car door from the inside to get out. At the same time use a screwdriver to push up the latch on the side of the door. Sometimes the seatbelt gets caught on the door when you close it causing the latch on the side to close prematurely

I would replace the pedal switch..cheaper way to go

It may be that you have a bad hydraulic lifter. Is the noise louder when you first start the car, and go a bit quitter after a few seconds. Unfortunately diagnosing noises in car without hearing them is almost impossible, so you will need to take it to a mechanic and have them check it out.

If you know the door latch is in the closed position, then I would assume you know where the latch is and what it looks like. You should be able to take a screwdriver of the handle of a pair of pliers and push the latch up until it clicks to lock open until you close the door. Hopefully this helps.

might need a new speedometer

The first thing to check is the ignition timing then the spark plug gaps. There are specific settings/size for the above and must be correct for the car to run smoothly.

is the temp gauge sender new or the engine cooling fans spinning fast enough air in the heating pipes ? bleeding

Could be pump gone.

Bulbs maybe when out you might want to check that first

you have a short. check cables at headlights and light switch.

15-18 lb

try wiggleling the key too the tumblers may be getting worn in the ignition is this works then replace the ignition

When you remove the door panel you will There is no track The Window Regulator is broken

Worn out & blocked exhaust converter They only last 12 to 14 years-- if that is misfire free years New Spark Plugs New Air Filter New Oxygen Sensors Clean MAF Sensor Check Converter Check Fuel Pressure Check for Vacuum Leak --intake,exhaust & evap system Worn Timing Chain

then check this wire from the relay to the pcm to see if there is a break in the wire or bad connection. if not then the pcm needs replacing. also check grounds for this circuit.

There is an ambient temp sensor behind the grill that might be in need of replacement.