I need a diagram for the serpentine belt
Posted by jcoomes83 on
HELLO THERE: Here is a link that will help you out ok dont forget to rate this soultion this helps me out too 1994 buick lesabre serpentine belt removal 1994 buick lesabre serpentine belt removal. Custom made wrestling belts ... money belt zipper. chest injuries from seat belts. serpentine belt diagram 30 mitsubishi ...beltpedia.info/1994-buick-lesabre-serpentine-belt-removal.html
Posted on Aug 18, 2009
where can a get a fuse box diagram for a 94 buick le sabre
Posted by edgar... on
firing order Diagram on 1994 buick lesabre 3.8L
Posted by cjh1132 on
For the 1994 Buick LeSabre 3.8L V6:
Ignition Coil Connections:
Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!
Posted on Jun 04, 2010
Warning light on dash -infl. Rest. What does it mean
Posted by nod612 on
Will it hurt the vehicle from it's everyday driving
Posted on Nov 18, 2018
HOW TO REPLACE FUEL PUMP IN A 1994 BUICK LESABRE
Posted by lytricie65 on
The fuel pump is located inside the fuel tank so you must first remove tank from car. After removing locate the wires going into tank. There is a large metal ring around wires. Remove ring by turning counter clockwise, then lift unit out of fuel tank. The pump is mounted in rubber at the end of fuel lines.
Posted on Aug 06, 2011
i need to know how to set the clock on a 94 buick lesabre it has the factory radio
Posted by amber... on
Setting the clock is easy. Place the key in the ignition and place in accessory. The clock should come on. Push the set button, on the right side, and use the scan/seek button to advance the time. Joe
Posted on Feb 17, 2009
Air will not blow out of the panel vents on any setting, instead it blows out of the floor vent and defrost vents
Posted by babygirl g on
vents are blocked so air is diverted to other vents, check and clean if necessary
Posted on Aug 14, 2008
i need the location of the fuel pump relay
The Fuel Pump Relay is located in the Relay Center. The Relay Center is located behind RH side of Instrument Panel (I/P) top of RH shroud. relay N
Posted on Nov 19, 2008
im not getting any power from my ignition to start my car,but lights radio etc.. is all working I need Major HELP.
Your vehicle is equipaded with Factory Anti Theft System.
Called Pass key II . If the mechanic found the Code
Pass key error....
Is there a few test to Do. to know exactly the problem.
1--- check if the Old and New key Are equipaded with a Little thing (Chip or Ressistence) in the center of the key.
If not you need a key with the chip. and the correct Ohms.
2. If you just replace the battery,
Full charge the battery Attemp to start the vehicle and leave the key in run position for exactly 11 Minutes, Them turn the key to off position for 30 seconds and try to start, if the vehicle start . you did the prosses to program the key.
If the vehicle not start.
Some times this procedure will require Up to 3 times to setup.
Or more with intervals of 30 minutes,, But if not start.
Remove the lower cover of the steering column. and the the Connector orange with 2 white wires shielded with a orange cover.
NOTE.. Be sure to not Confuse with the Yellow wires and connector, They are for the AIR BAG. Dont use a Convencinal Test light on any of the Mentionated wires....
After you find the wire and saw everything ok.
3-- You will need to remove the Ignition Lock cylinder.
The ignition lock cylinder is use 2 white wires shielded with orange cover, On 90% of the cases one of the wires come broken. and the ECM loss the comunication with the Chip incrusted in the key..
Posted on Dec 27, 2008
I'm looking for the turn signal flasher unit on a 1993 Buick LeSabre. I found the 4-way flasher which is clipped onto a support by the steering column but can't find the turn signal flasher. I bought a new flasher at the local GM dealer and a GM parts diagram shows a seperate flasher for turn signals and 4-ways but dosen't show the location where it is installed?????
Posted by c... on
The turn signal flasher is above the emergency brake petal and about 6 inches above, hid by a wiring harness. It is in a clip so pull it out and leave the wire hang to replace the new flasher. If you locate the fuse box drop it down by releasing the two metal clips left and right , the flasher will be directly above the left side of the panel.
Posted on Dec 05, 2011
1,318 questions posted
Usually answered in minutes!