20 Most Recent 1987 Oldsmobile Ninety Eight Questions & Answers

Our diagrams only go bact to the 1993 model year. If you wish to buy a used manual go here.

1987 Oldsmobile... | Answered on Oct 18, 2012

the fuse panel is under the dash on the drivers side check all the fuses.it could be the signal flasher there are two flashers one for the hazard lights and another one for the signal lights,they look the same.they are round and usually silver in colour some of them have a clear cover instead of a metal cover.

1987 Oldsmobile... | Answered on Apr 14, 2011

did you change the flasher relay ? it controls the flashers and the hazard

1987 Oldsmobile... | Answered on Jan 02, 2011

Welcome to FIxYa.com


Regards, Lee Davidian

Thank you for using FixYa,com.

1987 Oldsmobile... | Answered on Oct 23, 2010

engines have 4 components, air..sparks..fuel...exhaust.start with the cheapest and work through until problem solved...ie ht leads,when were they changed last or plugs, same thing.....even a lowly air filter will have a massive effect.(acts like a choke)

1987 Oldsmobile... | Answered on Oct 04, 2010

Hello hippy3369: My name is Roger and I will help. If the controls appear to be working and the air is fixed on the floor and out the defrost vent. Your problem most likely is under the hood of the car. Open the hood.Look fr a vacumn hose from the intake manifold and the fire wall. This hose should be around 5/16 of an inch. It wil run from the engine to a vacumn tank . Look in the center of the firewal just on the passenger side of the brake booster. The hose is prone to deteriation and will break causing a vacumn leak. This leak is the source of vacumn to the A/C controls. Replace the hose and you should be back to staying cool. The control head could also be the problem.But the most likely is the hose under the hood. Should you need further help please just ask. Please rate the answer as this way I know it was useful. Thank You for using Fix Ya. Roger

1987 Oldsmobile... | Answered on Jul 21, 2010

Sounds like crank sensor located behind crank pulley,or possible crank pulley comming apart.common

1987 Oldsmobile... | Answered on May 29, 2010

Check the ground to the fuel pump. It may be making bad/intermittent contact, causing the circuit to overload.

1987 Oldsmobile... | Answered on Dec 27, 2009

If you are trying to remove it, you have to use an oil change pan to catch the trans fluid. loosen all the bolts (15 of them if I remember) and then start from one end only and take them out. This will cause the fluid to flow into the pan, just make sure the catch basin is large enough. Good Luck.

1987 Oldsmobile... | Answered on Aug 22, 2009

Try cutting back the fuel intake. There should be a screw close to where the fuel line enters the carb. If there is a fuel injector It could be a few different places. GoodLuck And PEACE

1987 Oldsmobile... | Answered on Jun 13, 2008

a key code would be printed on the ignition cylinder

Oldsmobile... | Answered on Jan 23, 2014

Not finding what you are looking for?
Cars & Trucks Logo

21 questions posted

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ninety Oldsmobile

  • Ninety Oldsmobile

Most Popular Question

all lights work

  • Cars & Trucks