20 Most Recent 1991 Oldsmobile Ninety Eight Regency - Page 6 Questions & Answers

they are not supposed to!

1991 Oldsmobile... | Answered on Apr 07, 2010

behind the glove box on the passenger side. but ive only replaced 2 pcm's in that body style in all my years. are u sure thats whats causing your problem?

1991 Oldsmobile... | Answered on Feb 22, 2010

the piece you are referring to is a resistor of a specific value, witch compares to a value hardwired in the engine management computer, yes this can be the culprit, make certain the contacts are clean, use some fine steel wool to clean or an ink eraser is good to, there can also be a fault in the contacts in the key hole, especially is someone tried to steel you wheels inserting incorrect keys can also danage the contacts, do you have a shop manual for your ride ? let me know

1991 Oldsmobile... | Answered on Jan 31, 2010

How old is the battery?

1991 Oldsmobile... | Answered on Jan 30, 2010

I would check the power steering fluid level first and if its down repair the leak and recheck to see if its cured if there is no leaks and the level is fine ..Remove the serpintine belt and see if the pwr steering pump pulley pulls off. I have seen the pump shafts break and appear to be fine but they will pull out of the pumps...Good luck hope this helps..

1991 Oldsmobile... | Answered on Jan 24, 2010

Check the neutral safety switch,if it is o k,then replace the ignition switch,Not the key cylinder,but the electrical part.

1991 Oldsmobile... | Answered on Jan 23, 2010

NO, its not the filter, although it should be changed every year. It needs top be checked by a qualified repair shop. There are too many possibilities of what it COULD be. TPS and IAC are 2 that should be checked first. but you need special tools to check them.

1991 Oldsmobile... | Answered on Jan 17, 2010

Get some dryer sheets and moth balls and put them all over where the mice are.They will leave.They don`t like the smell.I can`t tell you where they are getting in because I don`t know but you will have to look around the vehicle and see if you can find a hole.It does not take a very gig hole either.Hope this helps.Good luck.

1991 Oldsmobile... | Answered on Jan 07, 2010

I would first make sure you in drive when shifting, don't go by the dashboard (you could have some slop in the shifter cable/rod) I you shift down 3 gears from park you should be in D and see if that still does the same, if it does your shift solenoids may be bad or worn clutch packs in the tranny.

1991 Oldsmobile... | Answered on Dec 21, 2009

bad rubber around doors, or warped door frames

1991 Oldsmobile... | Answered on Dec 18, 2009

turn on lights to low beam,test wire plug at headlight with test light,if you have power replace lights,if no power ,check for out going power at head light switch,if no power replace switch,if you do have power replace multi fuction switch

1991 Oldsmobile... | Answered on Dec 11, 2009

power steering pump,
check fluid first,if fluid is full it will need replaced

1991 Oldsmobile... | Answered on Dec 11, 2009

Based on the information you have given to this point, I am just going to give you a few possiblities. Have you had a tune up done recently? Air filter been checked or changed? I am not in any way trying to sound sarcastic so I apologize if I come off that way.Those would be my first things to inspect if I were ask to look at your car. I would also check fuel pressure and inspect the fuel pressure regulator.I would consider these things and go from there. I Hope this helps you but please let me know if you need more information on what to do next but I may need some more information at that time also .

1991 Oldsmobile... | Answered on Nov 11, 2009

The most common problem is the crank pickup going bad.
If you have never changed this sensor do it now....you will have to change it soon anyway.
Not expensive........it causes a lot of problems and fails often.

Do you see a check engine light come on when the car tries to stall?
Hopefully you do....it will help with a quick diagnosis's of the stalling problem.

1991 Oldsmobile... | Answered on Oct 20, 2009

Could the ignition light bulb itself be blown?

1991 Oldsmobile... | Answered on Oct 19, 2009

How do you bypass the chip that's on the key?

1991 Oldsmobile... | Answered on Oct 19, 2009

If the blower motor,or the cooling fans are staying on,then it is a relay stuck.Find the relay,by removing relays one by one,replacing them back as you go.When the relay is unplugged,the fan will go off,If you put it back in,it will probley not come back on unless you turn the ac back on,then it will do it again.Replace the relay with a new one.I hope this is helpful,let me know if it is.

1991 Oldsmobile... | Answered on Sep 29, 2009

Not finding what you are looking for?
Cars & Trucks Logo

196 questions posted

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Regency Oldsmobile

  • Regency Oldsmobile

Most Popular Question

cranks but no spark

  • Cars & Trucks