2003 Mercedes-Benz E-Class - Page 3 - Answered Questions & Fixed issues


What are break sensors?, all wheels have VSS vehicle speed sensors. Whats the issue?

2003... | Answered on Jan 08, 2013 | 95 views


hi i have mercedes 03 e500 my radio is probles sayed pleas closed

2003... | Answered on Dec 16, 2012 | 185 views


for a short fix it will work, but more than likely will blow that too eventually, it is that amp for a reason and anytime you are putting a bigger amp fuse in you are putting less protection into that part of the system which could result in the parts on that loop to be damaged.

Usually if the fuses blow constantly there is a short that is doing this, my advice is work out what that fuse is for and investigate that problem than trying to bypass it with heavier fuses.

2003... | Answered on Dec 10, 2012 | 318 views


The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM or ECM,ECU), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.

2003... | Answered on Nov 06, 2012 | 122 views


automatic gear on merecedes e220 stuck in first will not change up when accelerating could any one tell me how to get this fixed please

2003... | Answered on Nov 04, 2012 | 3,373 views


check fusees and bulbs then switches and then check wires hope its just a fuse

2003... | Answered on Nov 01, 2012 | 24 views


6 liters of that precious oil is needed.


2003... | Answered on Feb 07, 2013 | 1,163 views


I am so sorry but you must obtain this radio theft deterrent code from the dealer.

2003... | Answered on Oct 11, 2012 | 23 views


i take youve changed the hand brake shoes in the disc as you say the cable, have you adjusted the shoes through the wheel stud hole.

2003... | Answered on Sep 05, 2012 | 1,302 views


Sorry but we have no electrical diagrms here, check with the tow bar maker for help on this.

2003... | Answered on Aug 08, 2012 | 254 views


first,I would like to ask you if you've had your suspension,shocks,and tire air pressure checked for irregularities;second, do the weight differences between the dredominating driver and right side passenger(s) differ significantly enough to produce consistant weight burden on passenger side suspension,or shocks-less than on the driver's side of your vehicle? If any of the above issues or mechanical irregularities exist,then those are most likely the reasons for your vehicle being lower on right than on left.have a mechanic thoroughly check the suspension for wear,damage to components,and /or bent parts,and if all is well, and those possible components do not need need replacing,then the next area of concern would likely be shock obsorbers,and if those do not need replacing then the problem may be that the vehicle's frame is bent or broken -depending on the type of frame your vehicle has..Process of elimination,while troubleshooting likely areas of concern may enable you to find cost effective,timely solutions to any vehicular problems. Best of luck.Steve Smith

2003... | Answered on Jul 11, 2012 | 167 views


Sounds more like rear diff .otherwise drive shaft..get it up on a lift and let them check drive shaft play if none , diff

2003... | Answered on Mar 20, 2012 | 252 views


Your system air condition is controled by a climate control.The panel will be at fault,You can pull a code using a scan tool that reads MBZ climate control,The solution for the fix is the climate control this is a module

2003... | Answered on Mar 10, 2012 | 301 views


Click the link below to troubleshoot this problem: ---
Car loses power while acceleration? http://schematicsdiagram.blogspot.com/2011/12/car-loses-power-while-acceleration.html

----------
Loss of acceleration?

http://technoanswers.blogspot.in/2012/02/loss-of-acceleration.html

-----------
Acceleration lag problem?

http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html

--------------
How exactly the Vehicles Accelerator Cable works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-cable.html

-----------


How exactly Vehicles Accelerator Pump Diaphragm Works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-accelerator-pump.html

----------
accelerator pedal sensor?

http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

----------
stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

---------
Engine accelerates when brake is applied?

http://technoanswers.blogspot.in/2012/02/engine-accelerates-when-brake-is.html

-----------

This will help.

Thanks.

2003... | Answered on Feb 26, 2012 | 706 views


Condensation from your a/c can be found dripping off of a car. Make certain it is water and not coolant/antifreeze. If it has a sweet smell (coolant/antifreeze) then you may have a leak.

2003... | Answered on Feb 01, 2012 | 131 views


how do you change left low beam bulb on 2003 mercedes e320

2003... | Answered on Dec 27, 2011 | 2,922 views


notify dealer if u dont have it

2003... | Answered on Dec 01, 2011 | 885 views


2003 Mercedes-Benz E-Class

Service reset (including brake pads replacement)

10_7_2011_7_46_24_am.jpg10_7_2011_7_47_40_am.jpg
10_7_2011_7_48_09_am.jpg

2003... | Answered on Oct 07, 2011 | 588 views


Hello
You can't just swap around parts, you must perform actual electrical testing of the brake light circuit to do this use a Digital volt ohm meter (DVOM) to check and see if you have 12 volts at the socket when the brake is pressed, if you do show 12 volts then you need to check the ground wire connection, use an ohm meter and check the ground wire to the socket, should read less than 3 ohms from the ground to the chassis sheet metal, clean and repair as needed to restore ground if a problem is found. Brake lights can be on different fuses, one for left and one for right, check the owners manual for location of the brake light fuses, test them with an OHM meter, they can look ok and be open.

2003... | Answered on Sep 02, 2011 | 461 views


most likely a leak in the air suspension causing the compreesor to create a battery drainage

2003... | Answered on Aug 22, 2011 | 187 views

Not finding what you are looking for?
2003 Mercedes-Benz E-Class Logo

419 questions posted

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

jalal

Level 2 Expert

178 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...