1998 Mercedes-Benz E-Class - Answered Questions & Fixed issues

https://www.carstereocode.com/unlock.php?mk=26

Faulty motor or window switch

Check the seals on your injectors to make sure the are a tight fit .

nothing in the glove box book instructions you normally need a copy of CD /dvd for system in english .. ask at your nearest toyota dealer ship if one didnt come with the 2007 car this CD may be discontinued and you need to repalce the whole unit with a later model system

Before you suspect the transmission, check that the shift linkage is not misaligned or broken, Does it shift into any other gears.

It's likely a bad glow plug relay found on the left fender well. You may have bad glow plugs as well. You should hear a faint click when you turn the key to glow psn. . Open the hood and have someone glow it. The click should be abvious and the wires will run from the relay to the glow plugs. also obvious.

Rather involved , Will require a full set of workshop tools including torque wrenches. I advise against it . But if you decide to go ahead buy a workshop manual and follow it to the last word.

Just support the motor with a engine crane, remove bolts remove old mount fit new one may have to lift engine slightly to fit new mounts .

on the latch, it has a safety switch, find it and unplug it, the with a paper clip, bypass pins, close hood, if it work you need latch.

Have you check connection wireS, connector contact , finally the control switch ? Using contact cleaner to clear dirt at connector, checking connector pins as we'll. the wireS maybe broken ..

use compter or obd wifi to reset

Turn the key to the first on position and then hold the R and O button down until the languages came up. If you keep pushing the O button it wil scroll through the languages. Once you have it saying English, turn the key back off and then back on and the language will change..

won't your key open the door ?

heater control valve probably stuck ,locate it under hood right rear(heater hoses will be connected to it.) tap on it with air con. on and eng. running. if this fixes problem,valve will have4 to be replaced.

run fault codes to find the failed sensor/s. Check oil and coolant levels

brake switch sounds defective

either wheel sensor broken or lost,or relay.

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----

Mostly all types of car no start problems are discussed here with solutions:---

CAR NO START: ENGINE NOT TURNING OVER:

http://alltypesofpartsreplacing.blogspot.com/2012/11/car-no-start-engine-not-turning-over.html

---------

These will help.

Thanks.

front or rear

Check under the seat and see if something is jammed in Th tracks.