You have a engine ignition miss, poss defective coil, get the trouble code out of memory to find out which cylinder is the problem, Kragen does the trouble code test for free.
Seems like the fuel line looses its fuel or something. ????? That would cause a no start or hard start problem . Your best bet , have it diagnosed by a repair shop . That is unless you want 20 different answers on here . Are you willing to replace parts your vehicle doesn't need . Testing is the only way find the problem , not guessing , that's all you'll get on here . Hooking up a professional type scan tool an checking sensor data parameters to see what is a miss . Doing fuel pressure testing ,hooking up a pressure gauge .
007 Idle Speed Problems Scan Data for Idle
It may seam extremely complex this problem however its likely vary simple.What you need to do is fine out what works and what dose not . Dose the keyless work on other doors the battery is G or NG. You also mention the remote starter stopped working and D and P position no longer works correctly with the controls /switches in the drivers side door only' not the other doors ..
The control panel for the locks and window switches are on the arm rest drivers door it tends to get wet rain snow window open over time bad connections /switch contact and that is the point you need to look at first . Get some electrical contact cleaner spray into the switches not to much spillage use a tube or it may damage trim materials .
Then use the controls back and forth if you see any improvement of function starts /then stops any change you found the problem .Its in the door.
So , the power door locks won't lock or unlock with switches inside the vehicle or with the keyless entry remote fob.??? Is this correct ????
Do you know what a BCM - body control module is ? Do you know what diagnostic trouble codes are ? If not your best bet would be to take your vehicle to a GM dealer or someother qualified repair shop.
DTC B3142 or B3143
The body control module (BCM) provides an output to the driver switch assembly through the door unlock control circuit for controlling automatic door unlock, anti-lockout, and keyless entry unlock functions.
DTC B3152 or B3153
It could be the driver door master switch , could have broken wires inside the rubber boot from the body to the door . Do the power windows work ?
The keyless entry system has the following main components:
• The transmitters
• The body control module (BCM)
When you press a button on a transmitter, the transmitter sends a signal to the BCM. The BCM interprets the signal and activates the requested function.
How did you do this ,,checked and made sure locks and remote programmed,they were,but still do not work ?????
Need a scan tool to program
Important: All key fobs must be programmed each time any one fob is programmed. The scan tool must stay connected until all of the transmitters are programmed.
Install a scan tool and navigate to the BCM Module Setup menu.
Select Program Key Fobs.
Follow the scan tool on-screen directions.
When the programming operations have completed, operate the transmitter functions to verify correct system operation.
Could be the guides, but the head gasket could also be the problem if not installed correctly or the wrong one. Also check for excessive oil flow under the valve cover.
Battery Disconnect or Replacement Problems
Your going to have to take it to the dealer an have thing's reprogrmmed !
Important: Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle. The order in which the transmitters are programmed is important. The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. Use care to program the transmitters correctly.
Important: All key fobs must be programmed each time any one fob is programmed. The scan tool must stay connected until all of the transmitters are programmed.
Install a scan tool and navigate to the BCM Module Setup menu.
Select Program Key Fobs.
Follow the scan tool on-screen directions.
When the programming operations have completed, operate the transmitter functions to verify correct system operation