2000 buick century odometer does not iluminate
This is a common problem.
After many hours of internet research, I stumbled upon the only repair suggestion that sounded reasonable to me.
I performed the repair and it was successful.
I now have odometer and prnd321 lights.
There are four small resistors on the upper right section of the instrument cluster circuit board (just to the left of the tripmeter reset).
The solder connections of these resistors become corroded over time. Three fell to floor when I ran my finger over them.
I replaced the four resistors with 1/2 Watt 150 ohm resistors (soldering skills are required).
Posted on Mar 09, 2009
Where is the ECM located
The ECM is located on the right hand side under dash behind the glove compartment.Hope this helps.Good luck.
Posted on Jan 12, 2011
how do i set the clock in a 1992 buick century with stock radio
To set the clock, check this procedure:
1. With the radio ON or OFF, press SET. The SET indicatore will appear on the digitas display for five seconds.
2. You must begin to set the clock to the correct hour and minute during those five seconds. Press and hold SCAN until the correct hour appears on the display.
3. Press and hold SEEK until the correct minute appears on the display.
Hope help with this, remember rated this post, and TY for using Fixya.
Posted on Apr 15, 2010
My dash bored wont stay lite at night with my lights on in my 1992 Buick
There are few help links provided to resolve this issue of dash board light not working.Click the link below to go through its procedure:-----Dash board lights not working?
http://repairhelpcenter.blogspot.in/2012/02/dash-board-lights-not-working-on-gmc.html http://schematicsdiagram.blogspot.com/2011/12/heating-knob-light-bulb-under-dash.html ---------- Parking lights, tail lights and dash lights
not working?
http://technoanswers.blogspot.com/2012/01/parking-lightstail-lights-and-dash.html --------- How to replace Instrument panel and dashboard?
http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-instrument-panel-and.html ------- Tail lights and dash light fuse keeps blowing?
http://technoanswers.blogspot.in/2012/02/tail-lights-and-dash-light-fuse-keeps.html --------- This will help. Thanks.
----------- light in the dash blinks?
http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html
-----------Orange O/D warning light flashing on dash?
http://repairhelpcenter.blogspot.com/2012/01/orange-od-warning-light-flashing-on.html
---------gauge on the dash quit working on?
http://technoanswers.blogspot.com/2012/01/temperature-gauge-on-dash-quit-working.html---------No 4x4 light on dash?
http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html
----------Digital Dash Display not
working?
http://schematicsdiagram.blogspot.com/2011/12/cadillac-seville-digital-dash-display.html
---------warning on dash and alarm
sounds?
http://schematicsdiagram.blogspot.com/2011/12/chevrolet-tahoe-hood-open-warning-on.html
---------Light
Stays On dash of car?
http://schematicsdiagram.blogspot.com/2011/06/brake-indicator-light-stays-on-dash-of.html
----------The ABS
and Traction Control Lights stays ON dash of car?
http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html
----------warning lights remains
steady on dash?
http://schematicsdiagram.blogspot.com/2011/12/abs-brake-warning-lights-remains-steady.html
---------light bulb under dash
replacement?
Posted on Feb 19, 2012
was wondering where fuel pump is located and average cost to replace
IN Gas tank!! if you have no experience with this take it in get it done!! if you have a 1/2 tank of gas you will need a hoist!!or drain it some how that will weigh more than you can handel on your back! on the ground! it is hard to price it!!! if fuel lines ans gas tank straps are all reusable and do not break in the coarse of removal and installation and gas tank has no leaks and can be reused fuel pumps usually run $75-350 yours should be in the $65-$100 range!?? labour? what ever your garage will charge I did two fuel pumps and one new gas tanks yesterday 2 hours! but garages go by flat rate labour guides!!!!good luck hope this helps!
Posted on Jan 24, 2009
knocking noise coming from belt area. when belt removed and engine started knocking noise goes away. pulleys are all good, fluids ok, knocking noise increases when wheels are turned
Had the same issue and it turned out to be the balancer. Not too difficult to fix any questions or advice, I am happy to help you. Justlet me know. Good luck
Posted on Nov 22, 2009
i have spark and no fuel pulse on a 92 buick century with a 3.3 l. let me know what controls the injector pulse i tried a module but still same problem. fuel is getting to rail but no message at injectors.
looking at the schematics, well the PCM controls the pulse width to the injectors , BUT , there is a injector coil fuse , its #2 in your kick panel fuse box , a 20 amp , check it , sure hope that fix ya . that would be sweet .
J5
Posted on Jan 15, 2009
Fuse box 1992 buick century
Check this website
Buick Century 1993 fuse box diagram CARKNOWLEDGE
Posted on Oct 25, 2018
locating the fuse box for 1992 Buick century
On this website you find fuse box diagram and description for Buick Century (1992)
http://www.carknowledge.info/buick-century-1993-fuse-box-diagram
Posted on Oct 25, 2018
how do I replace mycrank sensor on a 1991 Buick Centry 3.3
Crankshaft Sensor
REMOVAL & INSTALLATION
3.8L Engine
On vehicles with a manual transaxles, the crankshaft position sensor is easily accessed from beneath the engine. On vehicles with automatic transaxles, the rack and pinion heat shield and the converter intermediate exhaust assembly must be removed first.
3X Sensor
Dual Crank Sensor
Sections 3 and 4 of this manual also cover testing, removal and installation, and adjustment of many computer controlled components.
24X Crank Sensor
To install:
Posted on Sep 24, 2010
455 questions posted
Usually answered in minutes!
921 Questions
813 Questions
785 Questions
797 Questions
687 Questions