Please don't forget to rate!
Composite Headlights
-
Open the hood.
-
Turn the bulb assembly counterclockwise 1/6 turn, pressing in firmly, until the flanges align with the slots in the retainer ring.
-
Pull out the bulb assembly. You may have to rock it up and down slightly to loosen it.
-
Disconnect the bulb base from the harness by lifting the plastic locking tab.
To install:
-
Snap a new bulb into the wiring harness. Make sure the locking tab is over the lock.
-
Install the bulb assembly by putting the small tab in the small notch in the retainer ring.
-
Turn the bulb assembly 1/6 turn clockwise to lock it in place
Non-European Style
-
Remove the headlamp trim panel attaching screws.
Remove the headlamp trim panel attaching screws
2. Remove the headlamp bulb retaining screws. Do not touch the two headlamp aiming screws, (at the top and side of the retaining ring), or the headlamp aim will have to be readjusted.
Remove the headlamp trim panel assembly from it's mounting location
3. Using a screwdriver, remove the retaining ring screws.
Using a screwdriver, remove the retaining ring screws
Once the retaining ring screws are removed, the ring can be pulled away
4. Pull the bulb and ring forward then separate them. Unplug the electrical connector from the rear of the bulb.
Pull the bulb out and unplug the electrical connector
To install:
-
Plug the new bulb into the electrical connector.
-
Install the bulb into the retaining ring and install the ring and bulb.
-
Install the trim panel.