20 Most Recent 1992 Dodge Spirit Questions & Answers

Check all ground wires for corrosion...clean and re-tighten.You could also use some dieelectric grease on them before re-tightening.

1992 Dodge... | Answered on Oct 04, 2019

That really depends on your engine size.
The 2.2L 4 cyl with and without turbo needs a rectangular
the 3L 6 cyl needs rectangular
the 2.5L 4 cyl needs round.

Really need to know what engine to be able to answer your question.
Semper Fi,

1992 Dodge... | Answered on Apr 28, 2017

you can go to the junk yard and get another barrel assembly , but you run the risk that you will have top reprogram the immobilizer
It may be cheaper to get a locksmith involved to fit a new barrel keyed to your existing key and that way the expense of programming the key to the immobilizer is avoided

1992 Dodge... | Answered on Apr 17, 2017

Under the dashboard should be a fuse panel and some turn signal flashers.
All of these are likely under the dash near the driver's knees.
Check the fuses first. (Probably not that), then try the turn signal flasher.
If your 4-way flasher is working, turn it on and take a flashlight and look up under the dash.
This will not be easy.
If you can locate the 4-way flasher by the clicking sound it is making, the turn signal flasher should be really near it.
They are often side-by-side.
If you will take it out, I hope a new one will fix it.
Be blessed.

1992 Dodge... | Answered on Dec 05, 2015

probably needs the catylitic convertor replaced

1992 Dodge... | Answered on Sep 26, 2014

Lean Fuel Mixture
Defective EGR System
Defective Catalytic Converter (CAT)
High Engine Mileage
Engine Overheating

1992 Dodge... | Answered on Jul 23, 2014

Remove Bolts Drop Pan, Clean all serfaces, Apply Gasket sealer /Gasket replace bolts tighten to 23 IN pounds/ Add Recommended Oil,
Run to Check for Leaks, Probably 1 hour will show any leaks if not done Properly

1992 Dodge... | Answered on Apr 18, 2014

Look under the hood to see some bare cables that connect the throttle pedal to the throttle body. Turn the idle screw clockwise 1/2 revolution at a time. Start the car, let it warm up and try it. Make sure the rpms aren't above 750 RPM or you'll risk crashing into someone. All this is assuming the car is in good tune, running well, has no major issues etc. These cars were pretty cheap and cheaply made so you may be limited by the age and lack of durability

1992 Dodge... | Answered on Dec 30, 2013

Wiring or connectors to horns are bad or disconnected, or most probably, the horns are bad from corrosion.

1992 Dodge... | Answered on Dec 03, 2013

Could be the trasmission safety switch, that prevents engine starting in gear, and allows it on PARK and NEUTRAL...

1992 Dodge... | Answered on Dec 03, 2013

Could be several things: if the computer is not receiving enough cooling air, it can shutdown to self protect. Another possibility, is the condition called "Vapor lock", where the engine does not receive liquid fuel because of the heat causing it to vaporize, specially if the fuel regulator has problems. Another could be the ignition coil failing when overly hot. ]without more info, it is impossible to know.

1992 Dodge... | Answered on Dec 03, 2013

Either you installed it wrongly, or the cap is old and the carbon contact inside is too worn; or you inadvertently damaged the distributor wiring exiting from the base of the cap, since old wiring insulation gets hard and brittle.

1992 Dodge... | Answered on Dec 02, 2013

Get a HAYNES or CHILTON manual. Is has all tghe steps and tightening torque values. The usual tightening sequence is to start at the center bolt, follow with the center one opposite to it, then follow an spiral going out until you reach the last bolt. As usual, you need to do it in three steps, with a decent torque wrench.

1992 Dodge... | Answered on Dec 02, 2013

You need to realign the tracks. Get a HAYNES or Chilton manual, it has the complete procedure.

1992 Dodge... | Answered on Dec 02, 2013

The electrical mechanism has a rotating arm with a wiper contact, whose objective is to prevent the wipers stopping in the middle of their travel, thus this small wiper contact continues to supply current to the wiper's motor until they reach the end position. From time to time, the wiper (or the electrical track support) rotates out of proper alignment, and just keeps the winshield wipers running. you need to disassemble the motor of the wipers, inside there is a small arm with a contact point, it need to be realigned. It is not difficult, but some dexterity is needed to be able to properly reassemble the motor.

1992 Dodge... | Answered on Dec 02, 2013

Not finding what you are looking for?
1992 Dodge Spirit Logo

Popular Tags

166 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1991 Dodge Spirit
1991 Dodge Spirit

143 Questions

1993 Dodge Spirit
1993 Dodge Spirit

140 Questions

1994 Dodge Spirit
1994 Dodge Spirit

126 Questions

1990 Dodge Spirit
1990 Dodge Spirit

69 Questions

1995 Dodge Spirit
1995 Dodge Spirit

59 Questions

Top Dodge Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Spirit Dodge

  • Spirit Dodge

Most Popular Question

radio interior lights dont work 1992

  • Cars & Trucks