2002 Mitsubishi Lancer - Answered Questions & Fixed issues

The fuel filter is located WITH the fuel pump AKA fuel module is what Mitsubishi calls this bundle, to access remove rear seats where you will find the cover to the assembly. The Fuel pump and Fuel Filter are intergrated to each other to save weight.

2002 Mitsubishi... | Answered on Jun 10, 2020 | 1,089 views

here is the wire diagram for your car this should fix your problem

2002 Mitsubishi... | Answered on Jun 04, 2020 | 802 views

The first step is to check the bulbs in the tail lights. The brake light switch (on the brake pedal) is OK, as the center light works.

2002 Mitsubishi... | Answered on May 02, 2019 | 120 views

hummm strange
does the master switch have a other door lock button

so central locking and windows dont work as they should

driver side window motor faulty

individual door lock actuator motors not getting power

it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner

2002 Mitsubishi... | Answered on Feb 07, 2019 | 142 views

The first step is to see what error code(s) are present. I suspect that a sensor or two may have been left unplugged or the harness is damaged during the trans swap. Check for bent pins in the connectors.

2002 Mitsubishi... | Answered on Jan 15, 2019 | 141 views

either check the circuitry , will need workshop grade equipment and expertise , which is the preferred option , or just change the sensor and hope it's that and not in the circuit , no real short cuts with these electronic problems

2002 Mitsubishi... | Answered on Dec 31, 2018 | 365 views

Here are instructions on how to remove a glove box on a Honda Accord: 1. Remove these items: Dashboard center lower cover and Passenger's dashboard lower cover. 2. Remove the screws from bottom of the glove box. 3. Wrap a flat-tip screwdriver with protective tape, and apply protective tape around the related parts, to prevent damage. Insert a flat-tip screwdriver in the notch of the cap, and release the hooks by prying up the cap. 4. Remove the screws. 5. Release the hooks, then pull down on

Car Diagnostic Tools

2002 Mitsubishi... | Answered on Jul 09, 2018 | 174 views

I tried the DIY
service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com

2002 Mitsubishi... | Answered on Mar 23, 2018 | 49 views

Sell the vehicle and purchase another.
Or determine that the cost of transmission replacement and having an operable vehicle is worth more to you, than the value of the car.

2002 Mitsubishi... | Answered on Jan 28, 2018 | 51 views

Anytime you are getting oil inside of the combustion chamber you are looking at an internal issue. Either valve stem seals, piston rings, or head gasket would be the most viable suspects.

2002 Mitsubishi... | Answered on Jan 05, 2018 | 169 views

There may be and indication if the battery is not being charged by the alternator, normally the ignition light will say on. Sounds like a bad diode pack in the alternator. Take it to and auto electrical shop to get that checked

2002 Mitsubishi... | Answered on Jan 03, 2018 | 29 views

Some you tube videos might help

2002 Mitsubishi... | Answered on Nov 02, 2017 | 424 views

run the fault codes
solenoids and servos do not operate unless they get a signal from the transmission ratio sensor , the Transmission control module or the VSS it will be revealed by a problem code

2002 Mitsubishi... | Answered on Oct 21, 2017 | 117 views

15w-30 engine oil and ATF transmission oil probably an atf -4 oil
ring any automatic transmission shop for the oil specs
make sure that it is a genuine automatic transmission and not a cv transmission ( constant velocity )transmission as using ATF oil will destroy the belt and the transmission

2002 Mitsubishi... | Answered on Oct 17, 2017 | 80 views

Repair your vehicle right away. Just click on the link I attached 2001 2003 Mitsubishi Lancer Evolution 7 EVO VII Service Repair Workshop...

2002 Mitsubishi... | Answered on Oct 13, 2017 | 154 views

Did you service the caliper slide pins to ensure the caliper slides freely? A rusted pin causes vibration.

Also check your ball joints and ties rod ends for wear. New bigger rims can accentuate worn components.

Do your new rims include hub adapter rings to EXACTLY center the rims on the hubs?

2002 Mitsubishi... | Answered on Sep 06, 2017 | 106 views

Start by verifying that the timing belt has not jumped a few teeth. You may also have a vacuum leak or poor fuel pressure. Undo the gas cap and see if the problem goes away. If it does, the fuel pump may be worn out.

2002 Mitsubishi... | Answered on Sep 06, 2017 | 117 views

Its just a relay they are cheap try replacing it , if that does not work,look for a bare wire and replace it. Or simply run a wire from fuse box that is key on hot only into the hot side of fan connector and a ground off other side of connector. It sounds harder than what it is.This way it comes on when you start it and off when you shut the vehicle down.

2002 Mitsubishi... | Answered on Sep 01, 2017 | 230 views

You are on the right track clean dirty throttle body.

2002 Mitsubishi... | Answered on Aug 05, 2017 | 42 views

Not finding what you are looking for?
2002 Mitsubishi Lancer Logo

1,447 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides