20 Most Recent 1998 Mitsubishi Montero Questions & Answers


1998 Mitsubishi... | Answered on Oct 08, 2019

Don't waste your money on unnecessary sources and unwanted repairs..
get this manual online at www.reliable-store.com get complete guide on whether to repair or not, service it, and how to repair etc

1998 Mitsubishi... | Answered on Mar 07, 2018

I'd check cylinder compression and go from there.

1998 Mitsubishi... | Answered on Mar 20, 2017

Hi Avocat

You can download a workshop manual free here.

Good Luck !

Please give me a FixYa rating please !



1998 Mitsubishi... | Answered on Feb 06, 2016

If it was turning over but not starting, you unfortunately wasted money or a battery and starter.
There is no magic "fix" button for a vehicle that will not start. You will need to have all stored codes read out from the ECU as a starting point, then proceed with regular diagnostic procedures to find the fault.
Change the fuel filter, replace all fuel in the vehicle to rule-out contamination, check the operation of the timing belt, and check for proper pressure at the fuel rail and for spark at all cylinders.

1998 Mitsubishi... | Answered on May 21, 2015

u damaged the valve train or damaged a piston--blue smoke means ur burning oil pull the plugs to determine which cylinder[s] is or are affected the plug would be fouled or have build up on it and do a compression test --possible problems--bent valve--burnt valve-bad valve guide --bad rocker- bad lifter- valve spring broken

1998 Mitsubishi... | Answered on Apr 28, 2015

the bulb is ok? visual check? switch the left and right side bulbs if they're easy to get to

hazard light swich on should flash both sides as well... is it doing that?

grounding issue on the left. gotta trace the ground wires of the left side and make sure the grounds are not corroded when bolted to the body of the vehicle

1998 Mitsubishi... | Answered on Apr 01, 2015

Bank 1 is on the side that cylinder number 1 is on, and 2 is on the other . Look up your firing order and you should find it fairly easily. And sensor 1&2 refers to before or behind catylitic converter.

1998 Mitsubishi... | Answered on Mar 29, 2015

With the connector halves close together can you tell which wire goes into the connector? Its probably the same color, but check anyway. Once you are sure you can follow that one back to where it comes from and check for power

How was the horn kit wiring harness installed? Was it patched in? Did it have its own wiring harness? Trying to figure out how that kit could have had any effect on the starter.

When the key is on do you have accessory power?

1998 Mitsubishi... | Answered on Nov 28, 2014

sounds like a blown main fuse. follow the positive cable from the battery to the fuse box. There should be a main fuse there, test to see if you have power on both sides. if not - bad fuse. also look at the cables and see if they're tight to the battery, and not rotted.

1998 Mitsubishi... | Answered on Dec 08, 2013

check the fusible link under the bonnet normally close to the battery . They are normally like a ceramic block about 6 together and you should be able to see in the top if they are good or not.

1998 Mitsubishi... | Answered on Dec 07, 2013

Not finding what you are looking for?
Cars & Trucks Logo

Popular Tags

147 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Montero Mitsubishi

  • Montero Mitsubishi

Most Popular Question

98mitsubishi montero check ingine light

  • Cars & Trucks