2004 Chevrolet TrailBlazer - Answered Questions & Fixed issues

It located behind the lower left side of dash.

2004 Chevrolet... | Answered on Oct 03, 2019 | 76 views

I would start with the checking the bulbs, fuses, then check the switch.

2004 Chevrolet... | Answered on Sep 16, 2019 | 418 views

Have you tried to add any refrigerant to it lately? The pressure can go up as it heats up, to the point where the pressure switch cuts the compressor off.

2004 Chevrolet... | Answered on Sep 15, 2019 | 61 views

Try right above your oil filter if it not there look on the front of the engine it's called a oil pressure switch

2004 Chevrolet... | Answered on Aug 21, 2019 | 57 views

The 2004 Trailblazer has two fuse panels, one in the under hood and one under the middle row seats. The radio fuse is marked RADIO fuse # 41 and is a 15 amp fuse located in the rear fuse panel. To access the rear fuse panel flip the seat behind the driver to the upright position, under it you can see the fuse panel and a diagram should be on the under side of the cover. 

Good luck and hope this helps.

2004 Chevrolet... | Answered on Jun 02, 2019 | 1,891 views

I disconnected the battery, removed fuses 10 and 28 adjacent the battery and waited twenty minutes. I then hooked the battery back up reinstalled the fuses and started the vehicle. The battery light went out and the battery not charging message did not come back on. I then went for a test drive. I had a celebratory adult beverage because it worked.

2004 Chevrolet... | Answered on May 22, 2019 | 2,101 views

Torque should be about 30-40 ft lbs. This is essentially tight by hand, no torque wrench is often used. See this how to video: Sorry the video wouldn't upload. But the shop (A1 Auto) tightened by hand and for me that's 30-40 ft lbs with open end wrenches.

2004 Chevrolet... | Answered on May 13, 2019 | 291 views

Check the idle air control device on the intake

2004 Chevrolet... | Answered on Apr 08, 2019 | 111 views

2004 Chevrolet... | Answered on Mar 16, 2019 | 212 views

How to remuve2005 trailblazer remove rear bumpier cover

2004 Chevrolet... | Answered on Feb 27, 2019 | 693 views

You probably have a front drive splined disconnect assembly that has gone bad. This assembly engages the front differential when 4WD is selected. Below is a figure of the item, it is on the passenger side of the differential area.


2004 Chevrolet... | Answered on Jan 12, 2019 | 3,114 views

If you have the two ends of the wires then they will have the same colors and you will have to put them back together. add new piece of wire if needed and make sure that they are secure. you can use plastic insulated connectors or solder them back together and use shrink tube to weather proof, soldering is the best way for a good connection to any wiring job.

2004 Chevrolet... | Answered on Dec 24, 2018 | 133 views

Not legally. If you do it illegally, you'll get a check engine light on full time.

2004 Chevrolet... | Answered on Jul 17, 2018 | 504 views

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

4,994 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides