20 Most Recent 1998 Chevrolet Malibu - Page 3 Questions & Answers

The fuse is on the driver side inside in the fuse panel or under the hood in the fuse box. Not of location but it has to be one of those two places.

1998 Chevrolet... | Answered on Oct 03, 2015

First thing to look at is coolant level. It sounds like the coolant pump will push coolant to the heater core and then stops pumping because it has air because to low. If coolant level is full, the vanes on the coolant pump might be spinning on the shaft, in which case you will have to replace the pump.

1998 Chevrolet... | Answered on Sep 25, 2015

Timing cover gasket or timing cover cracked this is timming cover

If you need further help, reach me via phone at https://www.6ya.com/expert/justin_f1b4194bdc162d2e

1998 Chevrolet... | Answered on Sep 25, 2015

try changing the altanator, it wont turn over if the altanator is burnt out .

1998 Chevrolet... | Answered on Sep 02, 2015

Save yourself some money , Take it to a ASE repair shop an have it diagnosed ! don't just replace parts have it hooked up to a diagnostic scan tool !

1998 Chevrolet... | Answered on Aug 09, 2015

Fallow the video and then soak it in water with dawn dish soap.

1998 Chevrolet... | Answered on Jul 27, 2015

First find leak and repair. Then draw vacuum for 30 min. or more, then add freon thru low side port.

1998 Chevrolet... | Answered on Jun 23, 2015

If car cranks his way but does not start 1 check your fuel filters for blockage. 2 check fuel lines make sure they are clear. If still not starting 3 replace fuel pump

1998 Chevrolet... | Answered on Jun 17, 2015

the wire ends have either a large eyelet or small eyelet. the small ones connect to the small terminal on the starter solenoid away form the motor and the large one to the larger terminal.

1998 Chevrolet... | Answered on Jun 10, 2015

probably a reverse solenoid /servo
run fault codes to determine if that or a problem TCM

1998 Chevrolet... | Answered on Jun 08, 2015

check connections from the battery to starter if ok tap on the starter with a hammer as a helper starts the engine if it starts replace starter before you do dose the key turn all the way forward normal starting position? reason i ask is why did you replace the ignition cyl lock?

1998 Chevrolet... | Answered on May 21, 2015

I would ask a mechanic about this as you could cause more problems if you get into this mess of wires and will cost you more in the long run. He should not charge just to answer a question.

1998 Chevrolet... | Answered on Apr 10, 2015

there are a number of reasons why you are losing power , vacuum leak will make it also run rough , bad wires . plugs , bad gas , do u have a ck eng light on if so find the codes , give me some more info after you ck this stuff out

1998 Chevrolet... | Answered on Mar 20, 2015

if you look near the gas pedal on the side of air duct or remove the glove box and on the top of air duct

hope it helps

1998 Chevrolet... | Answered on Mar 19, 2015

Buy a repair manual for the vehicle from your local auto parts store...they are under $20. The repair manual will show you step by step what needs to be done and more than likely has a few pictures to help out. Trying to write it out step by step here would take a long time and would be at least a few pages long.

Stuff to buy:
New Calipers
New Rotors
New Brake Pads
Brake Fluid
Brake Cleaner
Repair Manual
If the pads do not come with new clips, you may have to buy 2 of them.

Basic Tools needed:
Hex Wrench Set
Basic wrench set
Socket Set
Tire Iron
Floor Jack and Jack Stands
Hammer might come in useful, along with a bigger regular screw driver.
Sand Paper/Steel Brush
A helper to bleed the brakes.

If vehicle has ABS, that system also might need to be bled...repair manual will let you know.

Before installing the new rotors, spray/wipe them down good with brake Cleaner...they are oiled for storage/shipping.

Hope this helps.

1998 Chevrolet... | Answered on Mar 18, 2015

here, ill google translate this for you.
Question about 1998 Chevrolet Malibu Open Question I have a problem? with my Malibu to reach the temperature of 100 degrees antifreeze is pulled from the warehouse Whether you change temperature , radiator and tank sensor and nothing.

100C? is boiling temperature of pure water,sea level.
Normal temp is 87C. with anitfreeze the coolant boils at
132C. (under 12psi cap pressure)

over heating has many causes.
coolant not tool low? levels? inside RAD actual, dead cold.
got leaks?
try a new cap and new thermostat first , they are cheap.

1998 Chevrolet... | Answered on Mar 01, 2015

18 and 19 millimeter wrenches are needed and the power steering pump needs to be loosened or annattached as well as the power steering rack. good luck and use lots of cusswords

1998 Chevrolet... | Answered on Feb 22, 2015

Open up the hood. On the lens assembly there will be a couple of screws holding it in place. Loosen or remove these and pull the whole lens out the front of the vehicle. From there you can access the lamp for replacement.

1998 Chevrolet... | Answered on Feb 21, 2015

Intake manifold lower bolts two steps 5 FT-LBS then 9.58 FT-LBS(13 N-M)

1998 Chevrolet... | Answered on Feb 17, 2015

Not finding what you are looking for?
1998 Chevrolet Malibu Logo

1,550 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Malibu Chevrolet

  • Malibu Chevrolet

Most Popular Question

driving down road just cuts off but

  • Cars & Trucks