1993 Buick LeSabre - Answered Questions & Fixed issues
Where is the TDM located
The tdm ( theft deturent module ) for the car is above the hvac case behind the glove box . Lower the glove box and release the catches on the glove box to let it fall all the way down and the module is way up above the hvac case. The easiest way to by pass the vats system as long as the module is good is to measure the resistance of the pellets on the key and go to radio shack and get resistors that add up to the resistance of the key and wire them into the wires at the bottom of the steering column.This will trick the system that you are using the proper key .
6/27/2022 7:58:12 PM •
1993 Buick...
•
Answered
on Jun 27, 2022
•
924 views
92 LeSabre clutch replacement
Google it. You'll find a you tube video for just what you need to do. Just type into your search bar "1993 Buick LeSabre A/C clutch replace" and you'll find what I mean. A list of different tutorials to do just what you need done. I've used this method myself. The video's are usually done well and are complete. I can understand your situation.
12/7/2017 8:26:22 PM •
1993 Buick...
•
Answered
on Dec 07, 2017
•
85 views
I have a 93 lesabre. The air and heat controller
Hey Cap'n, all the heat and A/C is actuated by the controls and these controls are ALL vacuum actuated. Make sure you have vacuum to the controls from the engine. There's a 4 inch round ball under the hood on the pass side near firewall. This ball is the vacuum reservoir, must have vacuum to and from then thru the firewall to said controls. If there's vacuum everywhere, it HAS to work properly. Check all vacuum lines for leaks, cracks, connections, all the above.
7/20/2017 5:58:34 PM •
1993 Buick...
•
Answered
on Jul 20, 2017
•
253 views
Subframe
What is the vehicle? Sounds like you have junk now.
7/13/2017 4:42:29 PM •
1993 Buick...
•
Answered
on Jul 13, 2017
•
154 views
Throttle issue in a 93 Buick Lesabe
Has the ECT sensor been replaced, are all the sensor connectors in good condition, what fault codes are you getting when testing the system at the diagnostic port under the dash on drivers side? If you have not tested for fault codes here is a link to how it is done, the codes are read through the engine light blink method.
FAQ How to read older GM codes for free
3/24/2017 10:47:09 PM •
1993 Buick...
•
Answered
on Mar 24, 2017
•
122 views
I was driving home on the freeway and everything
Lose connection , broken wire inside the insulation . Where on the vehicle is the wire , how many wire's ? is it a whole wiring harness ? What color wire ? Open up the wiring harness an check the wire's one at a time . Pull on the wire's an see if one comes apart . If the wire is broke inside it's insulation you won't need to pull real hard for it to come a part .
3/17/2017 6:25:52 PM •
1993 Buick...
•
Answered
on Mar 17, 2017
•
71 views
Not finding what you are looking for?