20 Most Recent 2006 Nissan Frontier - Page 5 Questions & Answers

http://www.clubfrontier.org/ please go to this site. it is a lenghy job on this vehicle.when page comes up, just type in on left top of page--- pcv replacement on 2.5. good-day !

Pontiac

Thermostat

The obvious solution for your problem is to replace or reseal your oil pump.So what is your question?

If you do not know where the Camshaft Position Sensor is located, then it would be safe to assume that you have not properly tested the sensor or the circuits that operate the sensor. Therefore, you cannot possibly know for sure that it even NEEDS to be replaced...so why are you looking to replace it?

You must first diagnose and repair the malfunction that has caused your service engine light to come on in the first place (otherwise the light will just come back on again). Then you must use a scan tool to clear the computer memory.

• Here is the service manual in regards to removing, inspecting and replacing your rear axle. http://minus.com/mpNYuXxsB#1

• Hope this helps.

change your 02 sensor, bank 1 sensor 1 willl be a sensor screwed into a bung attached to the exaust before the catalyst. driver side

check mtr sounds like it weak will it come up if u give it a helping hand try pulling it the same time as using the button becareful not 2 jam your hand

there is no air problem but problem with sum air cheker system.