1996 BMW Z3 Roadster - Answered Questions & Fixed issues
Manual transmission hard to shift in first and reverse
Now assuming all the parts were correctly installed and the proper parts, are you sure the clutch fluid was bled properly? if there is even a bubble of air in there the clutch wont 100% disengage and cause more issues in 1st/rev. Some clutch systems need to be bled in a specific way and may not be as simple as others.
12/23/2017 7:58:04 AM •
1996 BMW Z3...
•
Answered
on Dec 23, 2017
•
289 views
I just purchased a 1996
Normally the dealer just needs to know the serial and it will give you the code in less than a minute. If the code they gave you doesn't work then the radio unit has been modified and the only ones that know what was modified are the ones that did it.
Just bite the bullet and get a new radio - one with an iPod hookup , your wife will appreciate that.
8/20/2014 7:45:32 PM •
1996 BMW Z3...
•
Answered
on Aug 20, 2014
•
720 views
Clutch problem
Pedal sinking to the floor is typically a failed master cylinder, failed slave cylinder and maybe both. A failing clutch has different symptoms (hard to shift, engine slips while in gear).
So good news because replacing both cylinder is cheaper than replacing the clutch. If you are mechanically inclined you can replace these yourself - I'd give it a medium on difficulty but you will be dealing with hydraulic fluid which can make a mess (and it will ruin your paint any place it touches).
On youtube there are dozens of videos on how to replace your master clutch cylinder and slave clutch cylinder (there is also a break master cylinder which is similar but not the same), So watch a few of them and see if you're up for it.
5/3/2014 4:52:21 PM •
1996 BMW Z3...
•
Answered
on May 03, 2014
•
283 views
Old battery would charge but had to charge everytime I drove it. Got new battery and will not crank, what to do?
There's a problem some where in the starter circuit or starter motor /solenoid etc.Check for bad ground frayed cable loose cable neutral/start switch needs adj. starter pinion jammed.If it started the first time after the new battery and then not the alternator may not be charging.The charging rate should be checked when the battery is replaced.If the headlights are very bright and the radio sounds loud and clear then the battery is not discharged.It should read a full 13volts if tested with a meter.
6/24/2013 6:10:27 PM •
1996 BMW Z3...
•
Answered
on Jun 24, 2013
•
79 views
Z3 ambient sensor
Hi Vintilairina, What do you want to know? It is mounted on the inside of the front bumper. Its purpose is to let you know the prevailing temperature outside your vehicle. It is a safety devise to let you know of ice conditions on the road. Regards John
9/8/2012 8:33:04 PM •
1996 BMW Z3...
•
Answered
on Sep 08, 2012
•
277 views
1997 z3 bmw radio lock vin#4uscj3324vlco7812
Getting the code to unlock the radio requires access to the factory data base, that is restricted and we do not have permission. You will need to contact the dealer for help with this. The original owner was given this code.
2/14/2012 9:33:47 PM •
1996 BMW Z3...
•
Answered
on Feb 14, 2012
•
336 views
Radio code
Hello, The only way I know of to get a radio code is from BMW itself. If you call your nearest BMW dealer and supply them with all the info they need, they can get it from BMW. You may be required to make available your registration and ID for them to process this.
I hope this helps.
CYA, Gator241
8/15/2011 6:38:46 AM •
1996 BMW Z3...
•
Answered
on Aug 15, 2011
•
639 views
Not finding what you are looking for?