20 Most Recent 1999 Oldsmobile Aurora Questions & Answers

Non working turn signals will not drain the battery because they work when the key is on. You may have a bad battery. If your signal lights come on and do not flash, you have a bad flasher which should be located under the dash area. As for the battery, most parts houses will check the condition of the new battery for free. If you think you have a bad battery, make sure that it has a good charge then disconnect it from the system by disconnection one of the cables. If the battery goes dead overnight then it is self draining.

1999 Oldsmobile... | Answered on Nov 14, 2018

Both switches are simple on/off, so you can test with an ohmmeter or just bypass with a paper clip. See your diagram at the link below.

1999 Oldsmobile... | Answered on Aug 01, 2017

It's on the right front corner of the engine comp. Then there is the one under the rear seat and the one on the drivers on the bottom of the door pillar (a-pillar).

Hope that helps

1999 Oldsmobile... | Answered on Jul 24, 2017

Your master switch is stuck in the running position and need to be replaced. Very simple to do. The reason your battery is running down is the switch is constantly activated and draining the system. Once you replace the switch everything will be good

1999 Oldsmobile... | Answered on Mar 29, 2017

These cars were designed to have daytime running lights, that can turn off with the ebrake being pulled, so perhaps whatever wiring mechanism that enable that, is failing.

1999 Oldsmobile... | Answered on Mar 21, 2017

No way to do this, the alternator is not made/engineered to use an off alternator external voltage regulator. Why would you need to do this?

1999 Oldsmobile... | Answered on Nov 16, 2016

Squeeze or slide the cover off . And the bulb will be attached at both ends , just grab at the center and pull it toward you !

1999 Oldsmobile... | Answered on Nov 12, 2016

It maybe tripped already , inspect the catch !

1999 Oldsmobile... | Answered on Nov 12, 2016

If there 8MM bolts then the torque is 16FT.LBS
if there 6 MM bolts then the torque is 8.5 FT.LBS

1999 Oldsmobile... | Answered on Oct 13, 2016

will need to remove door panel to inspect the lock rods ,clips and actuator ,,what usually happens is one of the lock rods either pops out of clip or clip breaks

1999 Oldsmobile... | Answered on Sep 16, 2016

1997 thru 1999 are the only interchangeable alt.

1999 Oldsmobile... | Answered on May 09, 2016

The fan should work off of the water temp. The fan will come on and off to keep the constant temp on the cooling water. If equipped with a second fan it is probably for the AC and will run when the A/C is on. If you think the fan should be on. Then If you know where the fan relay is check to see if it is hot, if real hot the relay may be going bad. Hope you know this when you turn the car off the fan can still come on if the water temp is to high. My thought fan going bad, temp sensor or relay may be the problem.. If you can touch the fan motor metal housing and it is real hot the fan man be going bad, remember the blades can start at any time.

1999 Oldsmobile... | Answered on May 01, 2016

Not finding what you are looking for?
1999 Oldsmobile Aurora Logo

528 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Aurora Oldsmobile

  • Aurora Oldsmobile

Most Popular Question

when driver side door lock stuck will

  • Cars & Trucks