20 Most Recent 2005 Nissan Altima - Page 5 Questions & Answers

Do you have two belts?

2005 Nissan... | Answered on Oct 13, 2016

When it stops remove fuel line to see if there is fuel present,if that's OK check for spark at one of the plugs,push a screw driver up the cover and hold near an earth crank the motor and a spark should jump off the screw driver to motor (earth)

2005 Nissan... | Answered on Oct 02, 2016

I would bypass the low cycling switch and service the ac first,or use direct power and ground to inspect the clutch,just make sure your compressor is not locked up first.

2005 Nissan... | Answered on Sep 05, 2016

This kind of cars the gas pedal is electronic, that means there is no metal cable to the carb. the first thing is check for any disconnected wire harness at the pedal or on the engine compartment at the throttle body everything looks fine the pedal could be defective

2005 Nissan... | Answered on Sep 02, 2016

You have to do electrical testing for fuel pump electrical circuit . Automotive Electrical troubleshooting Using Wiring schematics part 1 There are a lot of videos on you tube

2005 Nissan... | Answered on Jul 24, 2016

It doesn't have a "fuse" specific to the purge valve solenoid. What he is telling you is that you need to have this circuit troubleshot. Either the PCM the wiring going to the purge valve solenoid, or the purge valve solenoid itself is malfunctioning.

This requires a scanner, a digital volt ohm meter and some knowledge of when the purge valve actuates and under what conditions.

The car must be running and operating at cruising speed before the PCM sends a command to the purge valve to operate. Some scanners have the ability to send a request to the PCM to actuate the purge valve, but that scanner is usually a dealer's or equivalent.

2005 Nissan... | Answered on May 17, 2016

I am assuming that this vehicle has an electronic throttle control rather than an actual throttle cable.

You will need to get access to a scanner and check the code to determine whether you have a defective throttle position indicator at the pedal itself, wiring problems between the pedal and the PCM and the actuator to the throttle itself. You will also need access to a manual, and a good digital volt ohm meter.

If the vehicle has a mechanical braided cable on the side of the throttle, then you need to check for a broken throttle cable and replace if necessary.

2005 Nissan... | Answered on May 17, 2016

An auto parts supplier can tell you.

2005 Nissan... | Answered on May 03, 2016

Something may be intermittently heating up or a connection vibrating and causing temporary failure of the ignition or fuel system. Any recent work on the engine ?

2005 Nissan... | Answered on Apr 05, 2016

check your radio fuses-one under hood and another under dashboard.usually after power cut you have to re-enter radio security code to get it going again most car scanners can retrieve it if you don't have on.

2005 Nissan... | Answered on Mar 31, 2016

Not finding what you are looking for?
2005 Nissan Altima Logo

2,498 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2003 Nissan Altima
2003 Nissan Altima

1,415 Questions

2002 Nissan Altima
2002 Nissan Altima

1,259 Questions

2001 Nissan Altima
2001 Nissan Altima

550 Questions

1995 Nissan Altima
1995 Nissan Altima

522 Questions

1994 Nissan Altima
1994 Nissan Altima

400 Questions

Top Nissan Experts


Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Altima Nissan

  • Altima Nissan

Most Popular Question

2005 nissan altima 3 5 sl get radio work

  • Cars & Trucks