20 Most Recent
2003 BMW Z4 - Page 8 Questions & Answers
Top will delatch but doesn't retract.
it is on the driver side, there is a SIB on this and sould be covered under warr, what is happening is the motor fills with water and burns out, it is not easy at all to replace and the motor is expensive, when you get it replaced make sure they byutl cord the casing and drill drain holes so it does not happen again
3/31/2009 1:20:05 AM •
2003 BMW Z4
•
Answered
on Mar 31, 2009
How do you replace the bulb on the headlight of a
depends on if it is xenon or not if it is a xenon it is a good chance you are looking more than just a bulb possibly an ignigtor or a module or all three, if it is just a regular bulb then take the conector loose on the back of the bulb and then twist the bulb either left or rightit iwll come out if it has a holding ring then that is what you twist instead, KEY point make sure you have everything lined up like the tabs or it will fight you going back in
3/31/2009 1:17:32 AM •
2003 BMW Z4
•
Answered
on Mar 31, 2009
BMW Z4 will not move, seems like parking brake is still on?
Will the car roll? Put in neutral and try moving it? If not, your brakes might be the issue. Was the emergency brake on while stored? If it was, it is probably is locked in place. Your brake light wouldn't be on if this is what the problem is. Let me know how u make out.
3/22/2009 4:42:43 AM •
2003 BMW Z4
•
Answered
on Mar 22, 2009
BMW Z4 - stored for winter - how to "unlock" brakes?
first try starting car up, and put into rev. try backing up, in most cases this will release the ebrake.. if not try jacking car up, and pull on the ebrake cable with your hand, this should release the ebrake..good luck keith...
3/21/2009 3:06:24 PM •
2003 BMW Z4
•
Answered
on Mar 21, 2009
Washing your Cloth-top
Vacuum the top with a brush attachment, then rinse thoroughly with low pressure water to remove loose soil. Spray RaggTopp Cleaner evenly over the entire top and scrub lightly with a soft nylon brush. Then rinse thoroughly with low pressure water until no remaining soap foam is seen. If any difficult soiled areas remain they may now be spot cleaned by applying RaggTopp Cleaner directly, letting it stand for 10 to 20 minutes, scrubbing with a soft toothbrush, and then thoroughly rinsing the entire top again. Do not attempt to remove contaminants by scrapping with any sharp edged tool. When the top is clean dry it with a microfiber towel. After washing the top the car must be washed to prevent spotting or filming. Leave the top up until it is completely dry. This may take an hour in direct sun, or as much as 24 hours in cool, humid weather. After the top has thoroughly dried its water repellency must be renewed
Bmw trouble codes poo12
Likely the camshaft position sensor OR possibly a Vanos problem. The first is relative easy DIY the Vanos is more complicated. The Vanos will likely throw up a P0010 eventually.
Not finding what you are looking for?