20 Most Recent 2007 Acura RSX Questions & Answers

You need to have the immobilizer reprogrammed at the dealership. https://www.hondata.com/downloads/immobilizer_reprogram.pdf

2002 2006 Acura RSX Intake Manifold Gasket DNJ Acura Intake Manifold... Could this be of help, I've tried a manual on my bike.. Was pretty easy.

ensure you have enough transmission fluid, let vehicle run to warm up oil, block wheel and put transmission in neutral and verify oil while engine running, adjust as needed, if that doesnt work, possible torque converter mal function or shift solenoid, also check engine goes with a scan to verify possible transmission codes

Dee's Bail Bonds provides you with prompt, reliable advice and affordable & fairly priced bail bonds. We answers any questions you have about the process. http://deesbailbonds.com/ Richmond Bail Bonds 804 335 9599 Fastest Affordable

sounds to me like a starter issue. when the starter click andd it doesnt come popping out , usually its bad and has seized. as for you problem with the lights , that sounds like corroded grounds not giving a good pathway for the electricity . of course when you accelerate the alternator gives more power making it bright also the vibration is moving the connection around.

O2 sensor heater code. Replace sensor.

It should be the globe itself, the fuse will control many other things and if theyre not out it should just be the globe or possibly the switch that turns it on, check globe first.

sounds like the autoshutoff relay may be bad..it controls the ingition and the fuel pump too..if the pump works check for spark by inserting a screwdriver into a pulled off spark plug wire and look for a decent spark between the screwdriver shaft and any ground like the block..if no spark the relay may not be powering up the ignition system..

post the symptoms. (no start but cranks fine?) what? the relay only closes cranking. and may not if no spark, spark is first, after fuse checks. it (relay) is only a question, if? 1: fuel pressure is zero. 2: pump is silent while cranking. if you have spark on all cylinders and the fuel pressure is zero cranking or the pump has 0v not 12v cranking then we can show you where the relay is. or go to alldata.com and see it for self. some are in the fuse panel.... (im too lazy to look it up now)

It is a code for the Primary oxygen sensor.