2008 Mercury Sable - Answered Questions & Fixed issues
Where is the fuse for the cigarette lighter located in the 2008 mercury sable?
Take a test light and hook the clamp to a "good" ground and the point to each end of every fuse in the fuse box and you will find it .. make sure the key is on tho . If you get power at one end of the fuse you should have power at the other end . If not ,, you found a bad fuse . there could be more bad too . To make it easier I always go up and down each row of fuses so I dont miss any . Chuck
11/24/2021 12:41:11 AM •
2008 Mercury...
•
Answered
on Nov 24, 2021
•
92 views
Cd player doesn't work
Try loading an old CD under the "stuck" CD...this may take several attempts. Also you can go online using "stuck CD" and get several helpful tips...Hope this helps.
12/14/2011 1:12:32 PM •
2008 Mercury...
•
Answered
on Dec 14, 2011
•
703 views
I have a 2008 Mercury Sable that is having break
Take the rotor off and check the ebrake. If the rotor is hard to get off then the ebrake is holding it on and is most likely your problem. It won't be your master cylinder or proportioning valve because it is only affecting one side. Any questions feel free to email me at
[email protected]
8/7/2011 12:49:09 AM •
2008 Mercury...
•
Answered
on Aug 07, 2011
•
214 views
Controls in the steering wheel
Check your fuse panels for a burnt fuse. I would'nt recommend tearing into the steering wheel itself as you could deploy the airbag causing injury (and to replace one cost big $$$) Mike
6/14/2011 3:31:09 AM •
2008 Mercury...
•
Answered
on Jun 14, 2011
•
120 views
I bought a used Mercutry
there should be a reset button under the hood in the main fuse block block.
it has to be reset after every oil change
4/21/2011 4:03:18 AM •
2008 Mercury...
•
Answered
on Apr 21, 2011
•
183 views
2008 Sable, 57k miles. When I turn on the
My 2008 Sable, 22,000 miles. I have a steady clicking sound under the instrument panel and the car won't start. Right now, my vehicle was towed to the dealership, so I should find out something next week.
3/26/2011 10:40:30 PM •
2008 Mercury...
•
Answered
on Mar 26, 2011
•
469 views
I acnnot find how to
The following procedure will reset your oil change light. Thank you for using Fixya!
2008-2010 Sable
- Turn the ignition to run (one position before starting engine).
- Press and release SETUP to display "OIL LIFE XXX% HOLD RESET = NEW".
- Press and hold RESET for 2 seconds and release to reset the oil life to 100%.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
3/4/2011 3:54:43 PM •
2008 Mercury...
•
Answered
on Mar 04, 2011
•
743 views
Not finding what you are looking for?