20 Most Recent 2007 Infiniti Fx - Page 2 Questions & Answers


If the "dead" battery has a shorted cell, jumping doesnt always work.

Put the dead battery on a charger for an hour and see if it takes a charge. If it doesnt take a charge, replace.

Infiniti Cars &... | Answered on Dec 21, 2019


If the blower motor intermittently stops in all the speed selections. The problem will likely be the blower motor. I would not run out and buy a new motor until you inspect related components and see if you can identify other problems before ordering. It's possible that the climate control panel has a fault or the speed resistor. I would start at the blower and go to the next suspected component. If at the time the blower stops. If you tap on the blower housing and it starts to operate, that is it. Inspect the plug at the speed resistor and the blower motor. If the plugs and pins are damaged from overheating. They must be replaced before completing repairs.

Infiniti Cars &... | Answered on Dec 19, 2019


I think you should try this website big-manuals . It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page

Infiniti Cars &... | Answered on Dec 16, 2019


IF THE GAS CAP IS NOT WELL TIGHTING IT WILL THAT SERVICE ENGINE SOON OR IF THERE IS FUEL LEAKING ALONG THE FUEL LINE

Infiniti Cars &... | Answered on Dec 02, 2019


That is old, check wires near the wheel could be broken, any codes?

Infiniti Cars &... | Answered on Nov 11, 2019


While the problem might be a leaky head gasket or the degassing system blocked, the cause is probably an almost blocked heater matrix...

Infiniti Cars &... | Answered on Nov 07, 2019


If it were me, I'd pull the entire sending unit all in one piece from the junkyard and install it. Bet that would solve your problem. Sounds like something in the sending unit is bad or bent or something or not in tank properly which replacing the whole unit will solve.

Infiniti Cars &... | Answered on Oct 25, 2019


Could be lots of things...fuel pump, crank or cam sensor, a relay, etc

Infiniti Cars &... | Answered on Oct 14, 2019


Or remove other parts. I worked on a chevy blazer and had to remove the exhaust or take the starter apart in the hole. I took the starter apart saved me hours of work. Putting it together was a little tricky but not hard. I have even had to pull the radiator fan on some cars to get more room. Good luck. Try to remove less as possible

Infiniti Cars &... | Answered on Oct 12, 2019


What type headlamps ?
HEADLAMP (FOR USA) - XENON TYPE -..................46
HEADLAMP (FOR USA) - CONVENTIONAL TYPE -.
The headlamp operation is controlled by the lighting switch which is built into the combination switch and smart entrance control unit. And the headlamp battery saver system is controlled by the smart entrance control unit. OUTLINE NHEL0198S01 Power is supplied at all times I to headlamp LH relay terminals 1 and 3 I through 15A fuse (No. 68, located in the fuse and fusible link box), and I to headlamp RH relay terminals 1 and 3 I through 15A fuse (No. 69, located in the fuse and fusible link box), and I to smart entrance control unit terminal 49 I through 10A fuse [No. 13, located in the fuse block (J/B)]. When the ignition switch is in the ON or START position, power is supplied I to smart entrance control unit terminal 27 I through 10A fuse [No. 10, located in the fuse block (J/B)]. When the ignition switch is in the ACC or ON position, power is supplied I to smart entrance control unit terminal 26 I through 10A fuse [No. 1, located in the fuse block (J/B)] Ground is supplied I to smart entrance control unit terminals 43 and 64 I through body grounds M9, M25 and M87. Power Supply to Low Beam and High Beam NHEL0198S0101 When lighting switch is in 2ND or PASS position, ground is supplied I to headlamp LH relay terminal 2 from smart entrance control unit terminal 21 I through smart entrance control unit terminal 22, I from lighting switch terminal 12, and I to headlamp RH relay terminal 2 from smart entrance control unit terminal 59 I through smart entrance control unit terminal 60, I from lighting switch terminal 12. Headlamp relays (LH and RH) are energized and then power is supplied to headlamps (LH and RH).

Infiniti Cars &... | Answered on Sep 30, 2019


All of these responses are surely possibilities but I believe the brake control switch is out of adjustment. A simple look up of how to adjust the position on the switch should solve this issue. It is also possible the switch is broken as everything these days seem to be made of plastic. - - Good luck!

Infiniti Cars &... | Answered on Aug 23, 2019



I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

Infiniti Cars &... | Answered on Aug 15, 2019

Not finding what you are looking for?
Cars & Trucks Logo

2 questions posted

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6521 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Fx Infiniti

  • Fx Infiniti

Most Popular Question

infiniti fx carseat

  • Cars & Trucks
Loading...