20 Most Recent
Questions & Answers
Where is o2 sensor bank 1 sensor 2 located on 2007 honda ridgeline 3.5l
Some of these answers are confusing. On person says the sensor is near the catalytic converter, another says it's part of the engine.
I have a 2007 Honda Accord 6-cylinder, and received check engine code P0154, bank2, sensor 1.
Would this be near the catalytic converter, or would it be the first sensor on the right side of the engine (cylinder 4?)
I did drive through a puddle of water after a heavy rain (I'm guessing about 1.5 to 2 inches deep), so I'm guessing this caused it?
Thanks in advance for any advice/tips...
Honda ridgeline dash lights out
> ... > Interior
Jul 14, 2009 - 11 posts - 8 authors
Dashboard lights Interior. ... I read the threads about button lights burning out, has anyone had any problems with the gauge lights? I know the ...
Replacing dash board lights?
Nov 25, 2011
ABS, VSA and brake lights all on!
Jul 24, 2011
VSA, VTM, TMPS, ABS, Brake warning lights
May 30, 2010
VSA and warning light!
Feb 15, 2006
More results from www.ridgelineownersclub.com
How do you replace rear seat pulley on 2006 honda
To replace the filter on your Honda CBR - Locate your air filter, usually found on top of the engine. On cars with carburetors it is in a round piece of metal about the size of a medium pizza; fuel-injected cars have square or rectangular air filter housings that may be off to the side of the engine. Unscrew or unclamp the top to the air filter housing. Lift out the air filter. It should be a round or rectangular filter made of paper or plastic, with a rubber rim.lightdeal
How do you change tensioner pulley on honda honda ridgeline
As you can tell from the picture it isn't too easy to reach. So you'll want to go under the vehicle to get at it I think. Release tension on the belt by pulling on the tensioner pully, using the appropriate socket on the pullys' spindle bolt. Slip the belt off the tensioner and then remove the tensioner mounting bracket.
Not finding what you are looking for?