20 Most Recent
2007 Jaguar XK8 - Page 2 Questions & Answers
2000 XK8 New fuel pump and filter, still only 30psi get a lean code
Is it the PSI specs good {30PSI?} If not u have to start w checking 4 vacuum leaks, oxygen sensors, get emissions test to get all other emissions read (HC, NOX, CO) All the readings will give the tech a path. U have to have the right amt of fuel going into the pump & regulator to get the right PSI too. Clogged exhaust? The possibilities go on. Good Luck
The ABS+ETCS module on my 1997 XK8 went bad...
the electronic part of the unit ie. module is seperate from the pump unit and can be interchanged someone may have put a module from a different unit on to your pump motor unit ie, from a xkr which as a differant connector
2000 XK8 I locked the
Welcome to Fixya
The car might be stucked in Valet mode. Use the black key that you have to open the trunk, it overrides the
Valet Mode. The key goes in a hole that is between the X and the K on
the emblem on the rear of the car.
Thank you for using Fixya! If you need further help, reach me via phone at
https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
1997 jaguar XK8 My tail lights do not work. I
You've done most of the steps I would have so far... Now use a meter and trace the wires backward. Sounds like a broken or chewed up wire along the route backwards. Also try a separate wire with power to see if you can deliver power to those lights. If they work, albeit temporary for the test, you grounds are good. If one works and the other does not, then THAT ONE has a ground loss. In any case, you have it narrowed down, and I would hope that by now you may have your answer. Let us know so we can share our knowledge with other readers. Thank you!
What is range means on the message center?
Driving Range or Distance you can go at average mileage and amount of fuel in the gas tank. One of the items that will display if you poke one of the buttons to the right of the top of the speedometer.
How do i flush the hydrolic system for the
YOU DONT ,IF WORKING FINE YOU LEAVE ALONE,IF NOT THEN THERES THE ISSUE MOST COMMON PROBLEM IS SHAFT SEALS LEAKING ON THE PARTS THAT MOVE THE TOP,THEN THEY NEED REPLACED,,, SOME SYSTEMS USE BREAK FLUID SOME USE TRANS FLUID AND SOME USE A SPECIAL FLUID ,MAKE DOUBLE SURE BEFOR ATTEMPTING
Not finding what you are looking for?