Top 20 2007 Pontiac Solstice Convertible Questions & Answers


Bad bearings in gear shaft. Requires transmission rebuild or replacement. If only 15,000 miles, it should be under warranty.

2007 Pontiac... | 137 views | 0 helpful votes


They don't pay for repairs on 10 year old vehicles, and I agree with them.

2007 Pontiac... | 121 views | 0 helpful votes


If nothing is jammed, do it at high noon when the sun can heat and expand the top. It may have shrunk after being down.

2007 Pontiac... | 123 views | 0 helpful votes


dealer only to program the keys ,unless you have the fancy software and not program the key fob ,you need all the keys to be programmed and the computer with the OBDII interface and the correct software ,

2007 Pontiac... | 130 views | 0 helpful votes


manufactures used the cheapest tyres that a tyre manufacturer could supply in quantity. If one factory ran out then the next brand was fitted . So the car could have had goodyear for 6 months then the next shipment may have been bridgestone then dunlop depending who had what tyres during assembly.

2007 Pontiac... | 149 views | 0 helpful votes


head gasket hose you will have to check and see take a marror if you can't see in hard places to be able to

2007 Pontiac... | 96 views | 0 helpful votes


The Low Coolant is part of the Overflow Bottle, Check the Plug and if the plug is good, you will need to replace the Bottle. you can find a bottle for less than $100

2007 Pontiac... | 353 views | 1 helpful votes


Tape various areas where you think the problem is then road test it to see if it made a difference. If so you will have to find some way to alter the wind travel. If not, get out and move the tape to another suspect area.
Good luck!

2007 Pontiac... | 221 views | 0 helpful votes


Can you access the trunk by removing backing from inside the car ( passenger compartment)

2007 Pontiac... | 228 views | 0 helpful votes


Still have coolant leaving the exhaust,
means the problem wasn't diagnosed &
repaired properly


Not too many choices there

Head Gasket,intake,cracked head

Sounds like the head gasket wasn't
the only issue,something was missed
during the last reapair

2007 Pontiac... | 326 views | 0 helpful votes


P0420 - Catalyst System Efficiency Below Threshold Bank 1xicon.jpghttp://engine-codes.com/p0420.htmlForum CodePossible causes- Three way catalyst converter Bank 1
- Exhaust tube
- Intake air leaks
- Fuel injectors may be faulty
- Fuel injector leaks
- Spark plugs may be faulty
- Improper ignition timing
- Engine Control Module (ECM) Tech notes The most common cause it the three way catalyst converter Bank 1. Changing just the O2 sensor usually don't repair the problem. If the P0420 code is combined with other codes, try fixing the other codes first.

2007 Pontiac... | 1,065 views | 1 helpful votes


if it stills blows out air when not on a/c then it needs recharged, if your whole heating/cooling system failed you may need to replace it

2007 Pontiac... | 280 views | 0 helpful votes


Hi


At Least Once a Year one should perform Parking Brake and Automatic Transmission Park (P) Mechanism Check...

Caution: When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.

• To check the parking brake's holding ability: With the engine running and transmission in NEUTRAL (N), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.

• To check the PARK (P) mechanism's holding ability: With the engine running, shift to PARK (P). Then release the parking brake followed by the regular brake.
Contact your dealer/retailer if service is required

There is some information in the manual:-

Manual Transmission

Before leaving your manual transmission vehicle, fully press the clutch pedal in, move the shift lever in either FIRST (1) gear or REVERSE (R), and firmly apply the parking brake.

Park Brake Adjustment:-

Preliminary Procedures

1) Remove the front floor console.

2) Cycle the park lever several times. Verify the lever releases fully.

3) Turn the ignition ON. Verify the red BRAKE warning lamp is not illuminated. If the warning lamp is illuminated, verify the following:
3.1. The lever is fully released and against the stop.

3.2. There is not excessive slack in the cables.

3.3. If the warning lamp remained illuminated and there were no visible causes, refer to Symptoms - Hydraulic Brakes.

4) Turn the ignition OFF.

5) Raise and support the vehicle enough to raise the rear tire and wheel assemblies off the ground.


Procedure

1) Ensure the park brake lever is fully released.

2) Loosen the cable tension adjusting nut just enough to back the nut away from the lever cam.

3) Tighten the adjusting nut just until slack in the front cable is removed and the nut rests against the lever cam. The park brake cable adjusting nut is a nylon lock type. Use ONLY HAND TOOLS whenever tightening or loosening the adjusting nut.

4) Cycle the park brake lever several times.

5) With the lever fully released, tighten the adjusting nut just enough to remove slack in the front cable.

6) Raise the lever 1 detent position, then attempt to rotate the rear wheels.
Both sides should require high effort to rotate.

7) Raise the lever 1 more detent, to the second position, then attempt to rotate the rear wheels.
One side should be locked, the other side should require high effort to rotate.

8) Raise the lever 1 more detent, to the third detent position, then attempt to rotate the rear wheels.
Both sides should be locked.

9) Release the park brake lever, then rotate the rear wheels to inspect for drag.
There should not be any drag from the park brake system.

10) Inspect the brake caliper park brake levers to ensure that they are resting against the stops.


Please get back to us if you have further query else please accept the suggestion.

Thank you for contacting fixya.com

2007 Pontiac... | 1,942 views | 0 helpful votes


Hello robert.... Battery Replacement

Removal Procedure

Disconnect the negative battery cable (2). Refer to Battery Negative Cable Disconnect/Connect Procedure .

Remove the wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front .

Lower the vehicle.

Open the positive battery cable connection cover.

Loosen the positive battery cable bolt.

Remove the positive battery cable (1).

Remove the front fender rear bracket to side rail bolts.

Remove the front fender to front fender rear bracket upper (1) and lower (2) bolts.

Remove the front fender rear bracket.

Remove the battery hold down retainer bolt and retainer.

Important: Do not tip the battery more than 40 degrees during removal.

Remove the battery.



Installation Procedure

Important: Do not tip the battery more than 40 degrees during battery installation.

Install the battery.
Notice: Refer to Fastener Notice in Cautions and Notices.

Install the battery hold down retainer and bolt. Tighten the bolt to 25 N·m (18 lb ft).

Install the front fender rear bracket.

Install the front fender rear bracket to side rail bolts. Tighten the bolts to 20 N·m (15 lb ft).

Install the front fender to front fender rear bracket upper (1) and lower (2) bolts. Tighten the bolts to 20 N·m (15 lb ft).

Install the positive battery cable (1).

Tighten the positive battery cable bolt. Tighten the bolt to 17 N·m (13 lb ft).

Close the positive battery cable connection cover.

Install the wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front .

Connect the negative battery cable (2). Refer to Battery Negative Cable Disconnect/Connect Procedure .


Joe
Thanks for choosing Fixya!

2007 Pontiac... | 720 views | 1 helpful votes


Just turn off , all electrical load on your vehicle. Remove - pole of existing battery then + pole. Re fit new battery. Check your remote and player. Then set time on your dash.
Regards

2007 Pontiac... | 251 views | 2 helpful votes


Battery Replacement

Removal Procedure

Disconnect the negative battery cable (2). Refer to Battery Negative Cable Disconnect/Connect Procedure .

Remove the wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front .

Lower the vehicle.

Open the positive battery cable connection cover.

Loosen the positive battery cable bolt.

Remove the positive battery cable (1).

Remove the front fender rear bracket to side rail bolts.

Remove the front fender to front fender rear bracket upper (1) and lower (2) bolts.

Remove the front fender rear bracket.

Remove the battery hold down retainer bolt and retainer.

Important: Do not tip the battery more than 40 degrees during removal.

Remove the battery.



Installation Procedure

Important: Do not tip the battery more than 40 degrees during battery installation.

Install the battery.
Notice: Refer to Fastener Notice in Cautions and Notices.

Install the battery hold down retainer and bolt. Tighten the bolt to 25 N·m (18 lb ft).

Install the front fender rear bracket.

Install the front fender rear bracket to side rail bolts. Tighten the bolts to 20 N·m (15 lb ft).

Install the front fender to front fender rear bracket upper (1) and lower (2) bolts. Tighten the bolts to 20 N·m (15 lb ft).

Install the positive battery cable (1).

Tighten the positive battery cable bolt. Tighten the bolt to 17 N·m (13 lb ft).

Close the positive battery cable connection cover.

Install the wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front .

Connect the negative battery cable (2). Refer to Battery Negative Cable Disconnect/Connect Procedure . 1737d1122299169-solstice-service-battery-replacement-procedures-158wilmingtoncarshow36.jpg
hope this helps . please rate my response.

2007 Pontiac... | 500 views | 4 helpful votes


This car has self adjusters. They only work when the car moves in reverse and when the brakes are applied. Is that what you needed to know?

2007 Pontiac... | 1,125 views | 0 helpful votes


Un-hook one cable from your battery and leave it off for at least 20 minutes then hook it back up. That re-boots the computer. If the light comes back on then you have an actual problem. Take it to Advance Auto parts and they will read out the computer error codes for you and that will tell you what the computer thinks the problem is. Of course you may have to re-set your radio stations.

2007 Pontiac... | 256 views | 1 helpful votes


my 06 is doing the same thing on the passenger side...did you figure out how to fix it?

2007 Pontiac... | 312 views | 0 helpful votes

Not finding what you are looking for?
2007 Pontiac Solstice Convertible Logo

125 questions posted

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Solstice Pontiac

  • Solstice Pontiac

Most Popular Question

2007 pontiac solstice

  • Cars & Trucks
Loading...