20 Most Recent 2007 Volvo V70 Questions & Answers

have the fault codes read and fix the faulty sensors

lack of oil possibly. have you ever replaced the trans oil and filter? If not, next job to do.

Are you plugging into the obd2 diagnostics port under the dash or the diagnostics port under the hood? You should be plugged in under the dash to read codes for the MIL / ABS light. Just a heads up as well most scanners you can buy from the part stores do not have the necessary program protocols to read European cars.

For the RH headlight, First remove the top cover of the ECU module just behind the headlight. Then remove the middle section leaving the ECU in place. Both parts are just clipped in so should come out fairly easily. You will then be able to get access the the headlight bulb, release the spring clip at the top (using a mirror helps) and the bulb should come out.
For the LH side remove the air filter housing.

The sim slot is at the bottom of the button pad.

first thing to come to mind is a wheel bearing, being a noise that 'rumbles'-jacking it up, one wheel at a time and turning by hand might reveal which wheel is making the noise. Does the noise 'change' with speed, or braking? Noises are tough over the internet, but your description leads me to think they need to be checked first.

its a breather pipe

Sadly just hard work. remove whatever is obstructing your space and change the bulb then reaasseble.

Insert remote control in ignition slot. DO NOT depress any pedals. Press start/stop button once to switch ignition to position I. Press and hold button [A] 113463. Press and hold start/stop button for approximately 2 seconds to switch ignition ON. Wait 10 seconds. Release button [A] 113463 when information lamp [B] 113462 starts to flash. There will be an audible signal when reset is complete

BUTTON A IS TRIP BUTTON

I have got a Volvo v70 t5 with a telephone inbuilt, the only thing is i cant seem to find where you put a sim card, the manual says there should be a slot under the keypad but there is not one there

Hopefully this get's to you before you lock it up. If it get's locked up, it will read off in the display of the radio.

If that happens, you will need to leave the car in position one till the radio reads enter code.

You have 3 tries to get the code right.

Obviously you don't have the right one.

Pull the gear selector back to the lowest setting, hit the two tabs that hold the radio in and when those pop out...pull the radio out enough to get the serial number and part number. (just copy the label exactly as it reads and that will help)

Head over to your Volvo dealership and talk to the parts department, they should be able to get you the right radio code at no charge.