20 Most Recent 2007 Mitsubishi Eclipse Questions & Answers

0helpful
1answer

I have a 2007 mitsubishi eclipse 2.4l and I recently had to change the crank sensor. Before crank sensor went bad car ran great and was daily driver after I changed crank sensor it runs and drives great as long as it is on flat ground but has no power to go up hill. How do I fix this

Buy a new crank sensor from a Mitsubishi dealer. For that sensor always buy OEM parts. More expensive, but 100% reliable.Any codes? Maybe another sensor has gone bad? MAF?
1/20/2021 11:49:43 PM • 2007 Mitsubishi... • Answered on Jan 20, 2021
0helpful
1answer

Driver airbag and passenger seat belt lights stuck on

Disconnect the battery for 5 minuets, and it will clear the codes.
1/18/2018 1:31:54 AM • 2007 Mitsubishi... • Answered on Jan 18, 2018
0helpful
1answer

Code P0431, code P0421

I experienced the same. Rather than replace costly cats I tried to change gas to highest octane - and voila! - all lamps get off.
8/29/2017 7:18:25 PM • 2007 Mitsubishi... • Answered on Aug 29, 2017
0helpful
1answer

2007 mitsubishi eclipse hard to start after filling up tank. No check engine light on. Bad starter?

Maybe the carbon cannister is loaded up. Try parking the car facing uphill and see if that's better. Starter is probably OK. Need more symptoms. OR it will be 20 question time. Takes a LONG time cranking B-4 the engine begins to run? That's what I'm guessing. Does nothing to take the key back out and try it again.Just keep cranking until the engine starts to run.Don't be afraid to crank it for 15 seconds,or so.
11/17/2016 8:16:37 AM • 2007 Mitsubishi... • Answered on Nov 17, 2016
0helpful
1answer
0helpful
1answer

Would a broken balance shaft belt make a clicking noise and keep the car from atarting?

probably not but if may have damaged the timing belt and put the valve timing out and that would prevent the engine from starting
1/4/2016 5:08:27 AM • 2007 Mitsubishi... • Answered on Jan 04, 2016
0helpful
1answer

07 Mitsubishi eclipse fuse diagrams

Shop manual or owner's manual should have this.
6/12/2015 7:02:59 PM • 2007 Mitsubishi... • Answered on Jun 12, 2015
0helpful
1answer

I have a 2007 Mitsubishi eclipse,someone siphoned all my gas out So I went and put in 5 gallons. My car still won't start. Is there a restart switch? Or something I can do (inexpensive)

Might have burned out your fuel pump, its inside the tank and needs the fuel to be around it to keep it cool. Not widely known but running below a 1/4 tank can shorten the lifespan of the pump that and not changing the filter.
5/31/2015 12:28:46 PM • 2007 Mitsubishi... • Answered on May 31, 2015
0helpful
2answers

2007 Mitsubishi eclipse spider 2.4 blowing warm air not cold What is the paid supposed to be I know it takes 19 oz. Of freon I'm I suppose. To discharge before recharge?

Its best to evacuate the a/c but if you are careful you may be able to hook up your freon tank and lightly charge the system if it works cold just let it be and if when it is real hot it feels warm instead of cold you might add just a little more freon but be careful.
4/23/2015 3:58:10 PM • 2007 Mitsubishi... • Answered on Apr 23, 2015
0helpful
1answer

2007 Mitsubishi eclipse spider What is the p.s.I. suppose. To be on air condition I know it takes 19 oz. Of freon tried. To put a can of freon in and it won't take it

it won't take anything if the a/c clutch isn't engaging could have a deeper problem with system relays , clogged filter , evaporator , condenser ect should get system checked out
4/22/2015 9:59:28 PM • 2007 Mitsubishi... • Answered on Apr 22, 2015
0helpful
1answer

2007 Mitsubishi eclipse spider just put in clutch kit now it will not engage I can put it in gear without car on and I can push the car back and forth

Sounds possible you have the friction plate in backwards and there is no clearance. Retrace your steps and check the clutch operating mechanism, then any gear linkage. With the clutch centre plate, the raised part of the spring carrier is usually facing outwards toward the pressure plate fingers.
4/17/2015 8:29:40 PM • 2007 Mitsubishi... • Answered on Apr 17, 2015
0helpful
1answer

2007 Mitsubishi eclipse clutch was slipping but put in new clutch throw out bearing pressure plate had flywheel shaved now I have no gears checked gear oil it's level bleed lines and still no gears

how much was taken off flywheel ? was there a shim between crank and flywheel ? did you make sure spline count on clutch plate matched spline count and diameter on input shaft to transmission
4/17/2015 7:14:25 PM • 2007 Mitsubishi... • Answered on Apr 17, 2015
0helpful
1answer
Not finding what you are looking for?
2007 Mitsubishi Eclipse Logo

171 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22509 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15083 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Eclipse Mitsubishi

  • Eclipse Mitsubishi

Most Popular Question

2007 mitsubishi eclipse spider p s

  • Cars & Trucks
Loading...