20 Most Recent 2008 Dodge Caliber - Page 4 Questions & Answers

I suggest repair manual try filepeep.com or manualslib.com

you have a chain, no change interval needed unless you hear some noises that the guides are worn

take clove box out first un hook batt. un plug airbag it well unbolt

look under hood well be one if it has not been riped off

Most likely IAC dirty or sticking.

The one thing you need to remember with Dodge is, parts need to be car specific and parts with Dodge need to be Dodge OEM specific, some after parts can be used but, not a lot. I learned this the hard way, dealing with Dodge repairs on my automobiles as far back as 1987. If you want to make sure what you need and what you have are the right part, call any Dodge dealer and ask them, they won't charge you for the answer. This way, you are better safe than sorry.

Go to auto zone and find the hanse repair manual for you car if that doesn't work find a chilton manual one of them has to work and if all else fails go to a junk yard and get another air pump don't drive it to much if the pulley on the air pump seizes your stuck! Yours.Keith

Replace coils.

bad relay or bad earth cable

probably have to remove the door card to get access to bolts/nuts inside the door

if it's cable driven then the cable may have broken, if electrical then maybe loose connection or bad earth

get a diagnostic check done ? check for any warning lights on dash

There is no light that comes on for a bad starter sorry. Check your battery first and make sure that it has a charge on it, also check the cables make sure they are tight and clean.

This video should guide you though the procedure.

I have found this video that should guide you though the process.

heater core?

could be the setting on the switch or a blown light.

you need to get the OBD codes read ASAP as there could be a fault with the brake system , it may just be low fluid but don't take chances with brakes