20 Most Recent 2008 Dodge Viper Srt 10 Coupe - Page 2 Questions & Answers

sounds like you may have a short that is causing relay to fail so buy a circuit tester at parts store for few bucks and test wires to relay for shorts.

Check your ignition timing. It is advanced to far.

How do you know the Horn is the problem? In most cases it is not the Horn but the steering wheel rotating ribbon contact which is called the Clock-Spring (located under the steering wheel). With the car turned off you should be able to hear the Horn relay clicking when you press the horn button/switch, if not the Horn is not your bad part. To access the Horn on this car you will need to get under the front end, jack it up and place on support safety stands, the horn is tucked up in there on the drivers side.

#1; Is the battery dead? If you can get the car to a parts store,ie; Advanced Auto Parts, they will test the charging system free in most cases.#2 Starter solinoid is mostlikely gone if the engine does not turn over.

That is where you put the new plugs in it it is burning the extra gas and oil that was in the cyclinder it should clear up.if not you could have more problems then tune it up.

its in the fuel tank there may be a access panel or you may have to drop the tank.

You have a problem with your clutch. It may be leaking fluid from the master or slave cylinder. It could have air in the line. First, check the fluid level in the master cylinder and refill if necessary. Look inside the truck for a wet spot around the plunger going into the master cylinder. Finally, look under the truck for the slave cylinder to see if it is leaking. After replacing the leaking part, you will need to bleed the system to remove air.

You can purchase the power steering reservoir separately. Here is the contact information:

The Viper Store
13721 Linden Drive
Spring Hill, FL 34609

Fax number: 352 688 8153
Phone: 352 688 8160 M-F 10:30am - 4:00pm EST

email:
[email protected] Customer Service

Click on the link below to view more info:
http://www.theviperstore.com/SHOP%20-%20(Menus).htm

The fuel pump must have been bad.

does the trunk have a key? there may be a door release in the trunk, just like the corvette has

replace the computer and see if that works.

A few possibilities: Key FOB Proximity: If the key FOB is near the vehicle, the "Push to Start" screen might stay on. Door Sensor: If the vehicle's door sensor is malfunctioning or if the doors are not properly closed, it could cause the screen to stay on. Battery Issues: If there's an issue with the vehicle's battery or the battery of the key FOB, it could potentially cause this problem. It's also worth noting that some users have reported similar issues with their vehicles and have found success in disregarding the prompts asking to turn off/turn on the car You may have to go to a professional mechanic to get this properly diagnosed. That said, here is the service manual: https://cardiagn.com/dodge-charger-2015-2018-service-manual-wiring-diagrams/

Question edited for clarity. A 'witch' is a lady with a pointy hat that use a broomstick for transport. :>D The distributor will only go on one way that is a small notch in the cap that drops into a notch on the distributor body. Here is the 'firing order', what spark plug wire goes where. https://www.google.com/search?q=1978+dodge+tradesman+v8+firing+order ..

Question edited for clarity. 'Manuel' is the name a Spanish gentleman, a 'manual' is the book you need. There are some good ones in here. https://www.google.com/search?q=1978+Dodge+Tradesmen+manual ..

The ballast resistor in your 1997 Dodge B3500 van is situated under the exhaust manifold, where the engine and transmission connect. ballast resistor ' DodgeTalk Forum

The starter relay is found in the underhood fuse panel, located driver's side of the engine bay between the battery and the shock mount.

I suggest you take this to a TRAINED PROFESSIONAL.