20 Most Recent 2008 Ford Mustang Questions & Answers

Question edited for clarity. Out Fixya Pro Technician has the answer to this question from back in July! It must have had spam on it and has been removed. Jeff Armer Jul 13, 2022 Hook up a scan tool (a professional grade scan tool ) and check for DTC'S - diagnostic trouble codes in all the modules (computers) on the vehicle . One or more will probably have a code stored to tell you what might be wrong. ..

http://www.genuineservice.com/genuineservice/en/default?page=genuineService

Go to this website and pick owner guide in left task bar.Then input vehicle info and pick get owner guide. Then pick owner guide 3rd printing and your fuse info will begin on page 192.

if the serpentine belt is original then have it changed as it is probably hard and not gripping properly it is a reason that the ac compressor will not be at full efficiency , just like power steering not as good as it should be and alternator not charging properly the inspection of the belt is in the grooved section and it shows minute cracks in the groove ribs then it is overdue for a change

Take it back to where they were installed. High energy bulbs take hundreds or a thousand volts to get the to come on. Then 12 volts keep them running. Most likely the inline module is bad.

Get an inexpensive mechanics stethoscope and put the end on the shaft part of idler pulleys, housing near bearings of alternator and water pump etc. If that doesn't give clear results, try squirting a little water on the serpentine belt as if runs [a length of small drip irrigation hose works really well to get a little water on the belt]. The water will provide harmless temporary lubrication to the belt and change the sound if it is caused by the belt slipping.

Sounds like the windshield is leaking. Run water over the windshield and have someone get inside car and look for the leak. Alternatively take it to a reputable windshield repair shop and have them check it.

The A/C and heat is regulated by a vacuum activated door under the dash called the actuator door. There may be a vacuum leak causing the door not to work. Check under the hood on the driver's side. There is a vacuum manifold that provides vacuum for several different functions inside and underneath the hood. One will be marked A/C and have an arrow leading to the proper hose. Check all the hoses for leaks because if one leaks it will affect all the vacuum for all the other functions. Vacuum leak may be the problem.

you're on the right track, removing the serpentine belt and manually rotating/ spinning the pulleys listening for a dragging, or grinding. If its very bad you may even see a outward movement. hope this helps!

The fluid could be frozen in the hoses or the pump is broken. If you drive the car for awhile, the hoses will thaw out and the washers will work. Try getting fluid good to -20F. This fluid will be good for most areas in the US. Replace the pump if you turn on the switch and hear no sound from the engine bay. Have someone standing close by for this test.

Buy a service manual form your local parts store.that or go there. Autozone will give you a print out

i have same car and same problem if you find out let me know

1 Possible plugged 'Fresh Air' (Below cowl panel) water drain 2 Possible HVAC Evap Drain plugged or hose 'disconected' from Evap housing There are other possibilities...... If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

either the belt is stretched out or the tensioner is worn out