2007 Jeep Compass Limited - Answered Questions & Fixed issues
No Turning signals or windshield
When you don't know which fuse is which, I would go ahead and check them all. All you need is a 12 volt test light which has a sharp probe on one end and an alligator clip on the other end. Ground the alligator clip to a piece of metal by the fuse box. Then turn the ignition switch to the on position. Then probe both sides of every fuse. It should light on both sides. If you find a fuse that only lights on one side, that fuse is blown. If it doesn't light on either side, skip that fuse as that is not the bad one (those are generally for headlights or engine components). If none of the fuses light up, check your ground or change to another ground location. You can always check to make sure your tester is working by checking it across the battery. If it doesn't light there, the tester bulb is burnt out. When you find the blown fuse, replace it with the same color/same amps. Hope this helps. Good luck :O)
11/10/2023 1:26:24 PM •
2007 Jeep...
•
Answered
on Nov 10, 2023
•
1,268 views
What does wpr fuse mean
The WPR fuse is for the wiper and washer system. It is a 25 Amp fuse that powers up the WIPER HI relay, WIPER relay, and the WSH relay.
5/17/2020 3:36:16 PM •
2007 Jeep...
•
Answered
on May 17, 2020
•
5,541 views
Code sw ver 400, can ver 516, lin ver 429
Have a jeep patriot had a few issues with engine light coming on, took and had new sensor fitted stayed off a few days. Car shudders and jolts at low revs when accelerating sometimes and my mpg was at 25 around the town but now 18 maximum, need some help regarding wether it's worth taking back to have the light cleared to come back again! Worth a car battery reset? Also have a dodge petrol cap, takes ages to fill up stops every 50p of fuel, could this be the engine light problem or is their a separate light for that, any advice would mean the world regards
Don
12/10/2019 8:07:44 PM •
2007 Jeep...
•
Answered
on Dec 10, 2019
•
329 views
Is there a power windows fuse in 2007 jeep compass
Thank you Crip. I had the same problem with my 2007 Jeep Compass. Pulled the rubber hose back between the door and main body to find a broken wire! All sorted now, windows working fine.
10/25/2018 5:11:56 PM •
2007 Jeep...
•
Answered
on Oct 25, 2018
•
3,956 views
Where can I find a list of DTC codes ?
Don't know where you found those DTC'S , but they are not OBD 2 codes . DTC's come with a letter in the front of the number > P- for powertrain , engine , transmission . B - for body DTC'S - lights - C- chassis ABS .
Trouble Codes
3/18/2016 4:30:55 PM •
2007 Jeep...
•
Answered
on Mar 18, 2016
•
294 views
Left front window not working
It is probably your button. Pretty easy to replace and verify. If you take it out and cross the wires to open it, and it opens, then you know for sure it is the button.
1/21/2016 1:29:54 AM •
2007 Jeep...
•
Answered
on Jan 21, 2016
•
209 views
How do i replace the fan motor and where is it located?
wow, 3 fans in car and we get to guess,why.?
first what are you doing.? (guess,i want cab heat to blow?)
parked key off?
hot engine wanting heat from HVAC vents
? what?
or under hood and radiator fans are dead but overheated.
HVAC is a blower fan,or blower, the fuse is called blow.
does blower sound ok on high???? SouND?
if yes (if no controls are bad)
is air flow weak. yes. that is dampers failing
both the blower and dampers and heater core are in the center
tor right(usa) of dash in hugh black box.
first check fuses
then scan the car. yes, you must scan it see HVAC errors
or its all just a waste of time..
some models have filter and packed up ,my block air flow
some have it others dont,. not fun finding it.
most are behind glove box (after removal)
1/19/2016 12:40:31 PM •
2007 Jeep...
•
Answered
on Jan 19, 2016
•
160 views
How do you replace the horn on the 2007 jeep compass?
fuse 23 blown? is car battery discharged? (other symptoms not stated ?)my guess is you can't see the horn, and the bolt?.but can't reach it? that it?That is correct. the relay is buried deep inside the TIPM where I only go...and others ,not shy... im not so daft to replace a whole, TIPM for a bad relay or driver. for any horn... but you can....it is your cash.MP(49) schematic. is clear. as day.well was before fixya blurred it.(full)
1: is horn ground rusty? (look, examine...)2: does 12vdc reach horn , honking (a voltmeter tells you this)if #2 fails the PCM must be scanned to see why.a must. scan it NOW.B2336? B2338 (horn not grounded)b2371 is shorted hornlike that?if there is DTC that says the horn driver is bad, it is... end story. well, not doing the bad story.and swapping in new TIPM.'or reprogramming scrambled is dealer only fix.
9/6/2015 9:59:00 PM •
2007 Jeep...
•
Answered
on Sep 06, 2015
•
2,085 views
Not finding what you are looking for?