20 Most Recent
2007 Mazda 3 - Page 4 Questions & Answers
Mazda 3 2007 locked out will not start
dont bring it to a dealer-too $$ and average techs----its a warning lite for somethin mechanical or electric--wait a few min see wat hapens--a parts place can scan car for free and reset--pick up a repairbook for that model
4/30/2013 8:37:53 PM •
2007 Mazda 3
•
Answered
on Apr 30, 2013
EDR codes extracted
Last one is a code saying the bags deployed, I believe. Maybe massive water damage to sensors? 1994 is resistance too high on driver side curtain airbag, indicating an open circuit, and 2775 says short to ground indicating grounded circuit. Did they all occur simultaneously? If so, may be a direct result of deployment. Do not know why they deployed. Give as much info as possible.
4/19/2013 6:37:26 PM •
2007 Mazda 3
•
Answered
on Apr 19, 2013
I have a 2007 mazda3,and just changed the spark plugs and air filter. now it the motor rattles and shakes.
Was there a reason for changing the spark plugs, was it giving you a misfire code? I have an 08 mazda 6 and I've changed the spark plugs before without any problems, if the engine is rattling and shaking it may be a misfire from a faulty plug or a bad coil pack atop the spark plug. You should be getting a Check engine light on the dash if so take it to a local Autozone or Advance Auto Parts, they'll check the code for free.
2/11/2013 4:37:30 PM •
2007 Mazda 3
•
Answered
on Feb 11, 2013
How do you open up door to acess power window switch 2007 mazda 3
Places to look for screws (general guide, not model specific):1) within the door opener latch. Pop out any plastic backing plates.2) Beneath arm rest area. Pop out the arm rest if possible and inspect. Some screws may be located under a thin rubberized matting which sits in the arm rest/ door grab handle recess.3) Within the window switch cluster. The window switch cluster can be popped out on many models, without the need to remove the door panel.I haven't removed a Mazda 3 door panel before, but I have removed a Ford Focus panel (Based on the same model) and the panel pretty much just all popped off.The trick to removing panels is to pop off whatever you can, and then feel for where any tight bits may be, then look at that location carefully for screws or other types of retaining clips.
11/4/2012 2:30:32 PM •
2007 Mazda 3
•
Answered
on Nov 04, 2012
Not finding what you are looking for?