20 Most Recent 2009 Chevrolet Chevrolet HHR LT Questions & Answers

check fuses and relays--have vehicle scanned most auto stores offer this service for free if theirs a pending fault cruise may not work -- possible switch malfunction-check brake lights including 3rd brake light relays and brake light switch -

2009 Chevrolet... | Answered on Jul 27, 2016

1 Answer

2009 Chevy HHR water in floor passenger side front and back after heavy rain car was just sitting all day not driving where did 2 inches of clear water in floor come from,

Check the cabin air intake. Chances are the weather strip that lines part of the opening has come off. The intake should be accessible beneath the trim at the base of the windshield on the passenger side.

2009 Chevrolet... | Answered on May 31, 2016

0 Answers

Speakers only tweeters

2009 Chevrolet... | Posted on Jan 07, 2016 | Be the first to answer

0 Answers

Parking lights keep blowing fuses

2009 Chevrolet... | Posted on Dec 05, 2015 | Be the first to answer

1 Answer

Why do my Brake, ABS and Traction lights come on, the readout says traction ESC ?

take it back to the ppl that did the brake job

2009 Chevrolet... | Answered on Aug 06, 2015

0 Answers

GETTING DTC CODES P0700-TCM MIL REQUESTED, P0974- SS SHIFT SOLENOID A CONTROL CIRCUIT HIGH, AND P0977. SS SHIFT SOLENOID B CONTROL CIRCUIT HIGH.

2009 Chevrolet... | Posted on Jun 06, 2015 | Be the first to answer

2 Answers

Big pieces of paint are coming off on both side of the car , on the rear doors. No rust underneath. Anyone else having this issue?

Certain years of GM vehicles had peeling paint. The paint had a hard time sticking after exposure to sun

2009 Chevrolet... | Answered on May 03, 2015

1 Answer

Serivce air bags light came on

There are a number of reasons why the Service Air Bag light came on. Keep in mind, when the light is on, the air bags are disabled in the event of a crash. It is best to have it scanned and repaired by a reputable repair shop.

2009 Chevrolet... | Answered on Aug 15, 2014

1 Answer

Limbar support will no inflate

I would start by checking all of the electrical connections under the seat and at the lumbar support switch & motor, to make sure that they are not corroded and are tight. If the connections are okay, then I would suspect that the switch has failed. In this situation, an electrical tester (Ohm meter) would be your best friend. Unfortunately, new replacement parts may only be available from a dealer.

2009 Chevrolet... | Answered on Aug 09, 2014

0 Answers

Need to view wire diagram going to radio in 2009 chevy hhr lt

2009 Chevrolet... | Posted on Mar 30, 2013 | Be the first to answer

0 Answers

P0010 chevy hhr 2009

2009 Chevrolet... | Posted on Sep 07, 2012 | Be the first to answer

2 Answers

Flywheel bolt torque specs for a 1984 454 chevy engine

Second question about torque specs for this engine? A cheap shop manual will give you this and so much more. I always replace these bolts with ARP replacements on high performance or heavy pulling engines, so they have their own torque specs that come with the bolts.

Chevrolet Cars &... | Answered on Jan 13, 2021

0 Answers