20 Most Recent
2005 Toyota Tacoma PreRunner Questions & Answers
How do I adjust low idle adaptation on 2005 Tacoma prerunner 4.0
1. Relearn the idle speed by disconnecting the EFI fuse and the ECTS fuse from the under hood fuse box. Leave the fuses out for 2-3 minutes minimum. Reinstall the fuses. Using your finger, push the throttle plates closed completely. Hold the throttle plates closed completely and have a helper turn the ignition switch on. Release the throttle plates as soon as the key is turned on. Reinstall the boot to the throttle body and start the vehicle. Allow the vehicle to idle for 5 minutes. Test drive the vehicle and check for normal idle operation.
1999 Toyota Tacoma 2.4L sputtering
Mixture too rich. Make sure none of the injectors are leaking (any o-rings). Disconnect the battery to try and clear the ecu- sometimes it stores data on how the engine is running to adjust the fuel/air mixture. It may need to "reset" and start from scratch.
2014 Toyota Tacoma X-Cab: How can I remove the flip up headrests in the small x-cab rear sear?
The rear headrests are not a pull out design. They are bolted in place. You will need to remove the backrest panel to access the 4 bolts fastening each one to the rear bulkhead.
I think the panels are only held in place with 'push in' clips like door card panels. *Carefully* lever the sides of the panel towards you until you feel them pop loose. there is a good chance you will break some of this clips but they are cheap to buy. The panel unclips then slides UP and off.
If you are removing both headrests it might be easier to remove the entire panel to unbolt both headrests. This isn't a difficult job, it's just a pain in the tailbone to do and like most jobs on a vehicles it'll probably cost you the skin of at least one knuckle.
Not finding what you are looking for?