2006 Toyota Sequoia Limited - Answered Questions & Fixed issues

yes

It is the switch in the mirror motor and it seems to be happening to everyone who owns a Sequoia. The fix is expensive so I figured out if I physically hold both mirrors in place while hitting the console switch to fold the mirrors inward that the mirrors would stay in place and the running motor would shut off.

help in the link https://www.google.com/search?q=Toyota+Sequoia+stuck+in+4WD Some videos as well.

Clean the windshield using a strong glass cleaner, you have a road film build up. Also try RainX

Out of balance tires or a defective tire with a separated cord.

Here's the link and I'm sure you will get the solution of your problem- 2005 TOYOTA SEQUOIA SERVICE REPAIR MANUAL DOWNLOAD

You need a OBD2 scan tool to reset the codes.A cheap code reader is only $20

This website www.reliable-store.com has the largest collection of repair, service, parts manuals of any vehicle on earth. Best website I came across for manuals.. Also have live assistance

During all of this did anyone reset the ECM, if not then thats likely the problem!

Could be the idle controll sensor. But your on the right track. Clean the throttle body and map or maf sensor with the correct cleaner's. Get it at the parts store.could also be the pcv valve is carboned up.

follow this

Most likely a break in the wiring harness in the hinge area of the liftgate. Check for power and ground. If you don't have it, it's a wire or ground connection issue.

You must have these repaired by an authorized repair facility, check online you should be able to locate many of them..

Underside its engine.

Hooking up an ODB2 could give you some transmission codes.

in the fuse box

What do you mean disprogram your engine of a 03? If you mean will the engine still operate the same, yes it will. If anything, you may need to reset the radio clock (if you have one), maybe reset the radio station presets, and on some vehicles, may need a car code to allow the radio to turn on.

check fuse under dash left drivers side hard to see use glasses if ur over 40

Another item to check is if you have an aftermaket "coded / chip" key. If so, these may be the cause as they do not always trigger the anti-thief / alarm causing the engine not to start. It will turn over but will not start. Get an original key and again. Also, if you have other coded keys on your key ring, take them off and try again.

I have found the beeper wired into the reverse lights and if you just find the beeper and cut off the wire and cap it you should be fine and no more beep.