2005 Toyota Previa 2.4 - Answered Questions & Fixed issues

audio system bracket

2005 Toyota... | Answered on Apr 14, 2014 | 26 views

i would start by moving the coil packs, take the coil pack from cylinder 1 and put it on cylinder 3 and if your misfire switches to the no.1 cylinder you need a coil pack, It would probably run you about a 100$ for the coil pack

2005 Toyota... | Answered on Nov 23, 2012 | 249 views

Valve timing is out. Re-set

2005 Toyota... | Answered on Oct 04, 2012 | 46 views

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother

Toyota Previa... | Answered on Sep 23, 2019 | 22 views


It sounds like you have a loose connection either grab a torch and look under the dash as much as possible to see if any connections are loose or take it to an auto electrician and and ask for a quote to check out the issue.

Toyota Previa... | Answered on Jul 19, 2019 | 564 views

p1215 is the educational circuit Injectors That ControlA Peaks is in the engine compartment and has 8 pin module is not Working with the ecu you got That review also That relay is in the circuit. on this page I hope you got the diagram to help you


Toyota Previa... | Answered on Apr 02, 2019 | 7,209 views

toyotas website might have that

Toyota Previa... | Answered on Mar 08, 2019 | 30 views

If it has a fuse, or relay it will be in the fuse panel located under the hood on left side inner fender. (black box)

Toyota Previa... | Answered on Jan 16, 2019 | 40 views

remove the injector pipes and the guide tubes around them be careful not to crack them they will cause a bad oil leak

Toyota Previa... | Answered on Feb 04, 2018 | 196 views

There is a floor panel under the carpet inside the sliding side door. Remove that floor panel and you will have access to the top of the engine.

Toyota Previa... | Answered on Jan 01, 2018 | 174 views

How to replace a heater matrix for toyota previa 2.4 patrol 2005

Toyota Previa... | Answered on Jan 18, 2016 | 77 views

you must the coolint.

Toyota Previa... | Answered on Dec 31, 2015 | 616 views

You can't display English. Bit this site shows what the screens mean. http://au.toyotaownersclub.com/forums/topic/51250-toyota-blade-dashboard-display-japanese-to-english

Toyota Previa... | Answered on Jun 14, 2015 | 5,015 views

I replaced my drive shafts on my 96 Previa LE SC, so I know it can be done. If you don't know the difference between the auxiliary drive shaft and the front or rear drive shafts, then you probably want to have someone do it for you. The auxiliary drive shaft coupling replacement is a difficult job. It is covered in manuals available in auto parts stores. $20 for the manual is worth it if you decide to do it yourself.

Toyota Previa... | Answered on Mar 06, 2015 | 790 views

OK but is there a question here?

Toyota Previa... | Answered on May 17, 2014 | 44 views

this is the fuel filter location ,hope help.

Toyota Previa... | Answered on Mar 14, 2014 | 1,112 views

check the position of the switch on the light first. Check for earth points at the door switches or check the light control module . I have to suggest to check the blub as well

Toyota Previa... | Answered on Mar 02, 2014 | 118 views

for get radio.
does engine crank, lets work EFI and engines, (NO RUNS)
did you try a jump start? (cables) yet, ?
if the battery is low the radio might go nuts, like all digital electronics
do with way too low volts, below 10v they can go nuts. (crazy, crash, rest, or miscompute ,or get lost)
it is said computers dont make mistakes, well that is true with good power.

so tell us now what engine dont do right.
does it crank robustly?

Toyota Previa... | Answered on Feb 08, 2014 | 68 views

its too rich.
get the FSM and read how to test parts that control fuel mixture.
mech. injection
or EFI injection

Toyota Previa... | Answered on Feb 05, 2014 | 79 views

Not finding what you are looking for?
2005 Toyota Previa 2.4 Logo

Popular Tags

6 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides