2006 Toyota Previa 2.4 - Page 3 - Answered Questions & Fixed issues

Do a compression test to check for bent valves Check cam shaft position sensor. Check crank shaft position sensor Have the fault codes read for info as to what may be wrong.

One is on the slave and one is on the clutch master cylinder.Do the master first-at the bleeder or at the line 3 times.Then go to the slave cylinder. Do not pump the pedal-just old it down to bleed.the slave may not have a bleeder screw- just crack the feed line to bleed it.

The light come on when the system detects a problem and sets a trouble code. You should have it diagnosed and repaired with a airbag reset tool.

hello. i can assist you. i believe the fuse box you want is on the driver's side:

Transmission is a sealed unit. The filler plug is on the side of transmission and doubles as alevel plug. The filter is in the sump or oil pan of transmission and is only changed when serviced by someone who knows what they are doing. more to it than just changing the oil and filter and new gasket. Ps The best man for a job is a woman

chain driven or cam belt

you don't specify petrol or diesel ! If it's petrol (sorry gas ) I would suspect the A.I.C valve requires checking and possibly cleaning, this is the Automatic Idle Control valve, Usaully situated on the inlet manifold close to the throttle body, Cheers

seat belt sensor or air bag sensor, some cars measure weight in the seat on the passenger side and if it is below a certain amount it disables the passenger air bag, a safety for little kids, other sensor for seat belts, if there is any weight and no seat belt is fastened it will turn the seat belt warning light on in the dash.

oil filler underneath passenger seat lift back carpet twist knob and remove plate youll also on some models under the bonnet have a oil reserve bottle which should be full or at least 3 quarters full -estima emina 2.2 diesel

mounting rubbers or anti vibration rubbers

This make and model doesn't have a fuel pump cut off switch, the switch is only activated by an impact of 3 G's or more on cars and trucks that do use the switch. Spray starting fluid into the air intake of the engine, if it doesn't start you do not have a fuel pressure problem. Lots of things can keep a car engine from starting, you never mention any tests for fuel pressure or spark or proper valve timing (cam drive belt broken or jumped)

do you mean the silent blocks?there are tree off them left,right,and below backside.use one off these whit a wooden block on.tilt engine up just slightly the remove the arm and replce the silent blockengine can tilt little forhttp://www.totalcarparts.com/online-shop/mot1656-autokrik-p-2609.html?osCsid=799e3ca7df3568a036c2e8172feb3c2ewarts so take note.do one at the time .see pic

is the fuel pump running in the correct direction if you joined the wires up yourself this may be what has happened if it was not a plug. hope this helps

i need hellp i have no power to my new cd player can anyone help me to tell me which fuse is to the radio please there are loads i dont no which one please help i want to check that its not the fuse that has blown x

Keep an eye on you tachometer. When you are pretty sure it has shifted to the top "direct" gear, note the RPMs .Try to maintain the same MPH and then note when you think has shifed again. If the RPMs drop again, you then know it has gone into OD. Hope this helps you understand. Thanks, Robert

It means service needed.

low on oil or a bad sensor

if its the slarnt 4 mid mount mtr it maybe up front under the bonnet if not trace the fuel line back from the pump it should lead u to the filter housing

it may not be the starter motor it could be that the power isn't getting to the solenoid from the ignition switch, check all the wires & connections on the ignition switch to see if any are loose.........hope this helps.......cheers.

The best place to get one cheap would be a auto salvage yard. Call your local auto salvage dealer and ask if they have that make and model of vehicle in there yard. If they do they probably have the manual in that cars glove box and you can probably go pick it up for only a few dollars. If your local salvage yard does not have one you will probably have to go to the Toyota dealer and have one ordered. I hope this answers your question.