20 Most Recent
2006 Toyota Previa 2.4 - Page 3 Questions & Answers
Fuel filter location on toyota previa 1995
fsm quote
The fuel filter is located under the vehicle on the drivers side near the charcoal canister. Access is much easier from under the vehicle.
and some have a protective shield
in all cases, following the fuel line from tank youd have seen the filter.
for sure.
1995
Toyota previa problems
A/T car, auto or stick>
if A/T check the levels,,,, of fluid. ATF.
my guess. is the engine races real fast and car dont move,
right, this is called transmission slip or FLARE.
there are 2 issues, here, no engine power, RPM very low.all time.
or trans slip.
its one or the other.
Clutch slipping on toyota previa d4d 53 plate can it be tightened or will it need replacing
The first thing to check is the clutch release mechanism for faults. If a cable check that the clutch operates fully from dis-engaged to engaged as if the pressure plate is held 1/2 off then the clutch will slip. If hydraulic the same fault will be from a master cylinder that has a blockage in the compensating port. It is cheaper to fix the operating bits before pulling out the gear box because normally if a clutch is worn out or the pressure plate is broken you will go nowhere regardless.
Toyota previa 1995 tail light stays on
tail is park, so turn off the parking lights ,.there are 20+ lamps
inside and out for park/tail/dim dash lamps.
do you mean stop lights stuck on, id bet so. (parks out)
so replace or adjust the brake lamp switch.
see alldata.com for full facts on topic.
Tail light wire
Adjust the brake pedal switch located on the upper side of the brake pedal under the dash. To adjust the stop light switch, disconnect the two wires attached to the rear of the switch, move the switch by loosening the lock nut towards the brake pedal. As soon as the center pin of the switch begins to touch the brake pedal notch, rotate the switch half turn more and lock it by tightening the lock nut. Connect the wires back and ask your companion to see the tail lamps while you depress and release the brake pedal. Or you can see the tail lamp behavior by parking the car on reverse at a distance of one foot from any wall.
I have a replacement aftermarket blower motor
Cut the old terminal plug and tap it to aftermarket blower motor so that you can use the same plug without any hazzle. But please make sure you tap it to the right polarity, the positive and negative.
Not finding what you are looking for?