2004 Toyota Previa 2.0 - Page 2 - Answered Questions & Fixed issues


looks mean nothing if they all look good
there are 2 fuse boxes (you never said which lamp.??????) up to 20 lamps inside a car.... most cars....
the cab fuse box is my guess
use and ohmeter to read the fuses, for dome, cluster , dash, or like names.
0 ohms is good, RX1 range) and infinity is bad. every time.
fuses can get hair line cracks, that eyes can NOT SEE.

alldata.com is good for USA cars. do cant help you , in UK (bonnet land)

Toyota Previa... | Answered on Feb 02, 2014 | 44 views


no year, no joy, not ever.
why are you looking for it.
engine dead, or someone told you it needs replacement or????

Toyota Previa... | Answered on Feb 01, 2014 | 18 views


fsm quote
The fuel filter is located under the vehicle on the drivers side near the charcoal canister. Access is much easier from under the vehicle.

and some have a protective shield
in all cases, following the fuel line from tank youd have seen the filter.
for sure.
1995

Toyota Previa... | Answered on Feb 01, 2014 | 194 views


You can download very easy the service manual for toyota previa. Recommend this website, is 100% safe.

Toyota Previa... | Answered on Jan 06, 2014 | 321 views


A/T car, auto or stick>
if A/T check the levels,,,, of fluid. ATF.
my guess. is the engine races real fast and car dont move,
right, this is called transmission slip or FLARE.
there are 2 issues, here, no engine power, RPM very low.all time.
or trans slip.
its one or the other.

Toyota Previa... | Answered on Jan 02, 2014 | 101 views


FSM
buy one, at,, drum rollllllllll, toyota.

Toyota Previa... | Answered on Dec 22, 2013 | 40 views


The first thing to check is the clutch release mechanism for faults. If a cable check that the clutch operates fully from dis-engaged to engaged as if the pressure plate is held 1/2 off then the clutch will slip. If hydraulic the same fault will be from a master cylinder that has a blockage in the compensating port. It is cheaper to fix the operating bits before pulling out the gear box because normally if a clutch is worn out or the pressure plate is broken you will go nowhere regardless.

Toyota Previa... | Answered on Dec 11, 2013 | 225 views


tail is park, so turn off the parking lights ,.there are 20+ lamps
inside and out for park/tail/dim dash lamps.
do you mean stop lights stuck on, id bet so. (parks out)
so replace or adjust the brake lamp switch.
see alldata.com for full facts on topic.

Toyota Previa... | Answered on Dec 07, 2013 | 235 views


Adjust the brake pedal switch located on the upper side of the brake pedal under the dash. To adjust the stop light switch, disconnect the two wires attached to the rear of the switch, move the switch by loosening the lock nut towards the brake pedal. As soon as the center pin of the switch begins to touch the brake pedal notch, rotate the switch half turn more and lock it by tightening the lock nut. Connect the wires back and ask your companion to see the tail lamps while you depress and release the brake pedal. Or you can see the tail lamp behavior by parking the car on reverse at a distance of one foot from any wall.

Toyota Previa... | Answered on Dec 06, 2013 | 159 views


Change fuel filter first. Could be a number of things but you aren't giving enough information.

Toyota Previa... | Answered on Nov 03, 2013 | 45 views


Check antifreeze,coolant,thermostat could be seized controls when engine is hot for heat

Toyota Previa... | Answered on Nov 02, 2013 | 130 views


Cut the old terminal plug and tap it to aftermarket blower motor so that you can use the same plug without any hazzle. But please make sure you tap it to the right polarity, the positive and negative.

Toyota Previa... | Answered on Oct 18, 2013 | 34 views


Did you get the timing marks in the right place? All wires plugged in?

Toyota Previa... | Answered on Oct 16, 2013 | 51 views


Normally, this is caused due to Sand or not enough lubrication. If you do not have some technical knowledge on it , it will be wise to take it to a repairman

Toyota Previa... | Answered on Oct 15, 2013 | 148 views


That could be very dangerous. It could be bad wheel beaings or a broken suspension part. Could also be something wrong with the power steering but be safe and get this checked out by a shop asap.

Toyota Previa... | Answered on Oct 11, 2013 | 40 views


It could be:
-Poor fuel. (Not enough pressure)
-Bad injector. (Not open and let fuel in when NEED)
-Burn or broken spark plug wire (So it spark to metal instead at the tip of the spark plug)

Mai

Toyota Previa... | Answered on Oct 10, 2013 | 24 views


please RUN the scanner and computer for diagnostic. can be a sensors faulty. and make the TUNE UP. some cable, spark plug, or EMP defective, or coil.
God bless you

Toyota Previa... | Answered on Oct 02, 2013 | 285 views


check for worn or broken motor or trans mounts

Toyota Previa... | Answered on Sep 03, 2013 | 146 views


remote for my Ford Taraus will work inside car, but not on the outside.

Toyota Previa... | Answered on Aug 04, 2013 | 18 views


Can you remove plug.

Toyota Previa... | Answered on Jun 10, 2013 | 64 views

Not finding what you are looking for?
2004 Toyota Previa 2.0 Logo

5 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Mike

Level 3 Expert

4369 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...