Top 20 2007 Suzuki Forenza Questions & Answers

1helpful
1answer

I am customizing a 2007 Suzuki Forenza and Engine. looking for any other that are working on a2007 Suzuki Forenza Engine?

go to forenza/suzki forum or a tuner forum
10/27/2021 8:28:57 PM • 2007 Suzuki... • 59 views • 1 helpful votes
0helpful
1answer

How can I set the timing and firing order?

Engine timing is done electronically. It is based on Cylinder 1 being a few degrees before TDC (Top Dead Centre of firing stroke). Valve Timing is set using marks when you change the timing belt or chain. That is set with Piston 1 at TDC on FIRING stroke. Here is the firing order. It is nice and easy, 1, 2, 3, 4, left to right. https://www.google.com/search?q=2007+suzuki+forenza+firing+order ..
7/23/2021 9:46:04 AM • 2007 Suzuki... • 406 views • 0 helpful votes
1helpful
1answer

Bought new windshield wiper motor for 2007 Suzuki forenza and switch works motor does not

use a meter and test motor and power connections
7/18/2021 1:59:40 PM • 2007 Suzuki... • 103 views • 1 helpful votes
0helpful
1answer

A 2007 Suzuki forenza 200,005 miles

fuel filter or fuel injector.
8/12/2021 11:17:08 AM • 2007 Suzuki... • 41 views • 0 helpful votes
0helpful
1answer

Is there a fuse to the alternator on a 2007 suzuki forenza

There is a voltage regulator. It can cause charging problems. The brushes are sticking it will charge when turning but can pass good when testing even when bad. https://www.carparts.com/classroom/charging.htm
3/10/2019 10:10:59 AM • 2007 Suzuki... • 465 views • 0 helpful votes
0helpful
1answer

Torque specs for head bolts on 2007 Suzuki forenza 2.0l

http://www.championbrands.com/aera-torquespecs.pdf Here are the touque specs manual
8/1/2018 2:50:57 PM • 2007 Suzuki... • 2,078 views • 0 helpful votes
0helpful
1answer

I got a 07 forenza that has coils 1 through 4 misfiring.it starts and idles fine but when i push gas it misses and tries to line out.what could cause this

lean out? check fuel pressure? to spec, in the service manual? new spark plugs. 11 old plugs are no good maf sensor dirty? no engine told at all, 2.0L 2000cc, USA? no country told. 4+ engines used world wide. so.... USA is , a gasoline-powered 2.0 L 4-cylinder E-TEC II made by Holden, that is correct,Holden is Austrialian I say no stranger car exists on earth./ the wiki on it can make anyone cry , or run in fear. what mix of parts.
4/12/2018 3:07:33 AM • 2007 Suzuki... • 332 views • 0 helpful votes
0helpful
1answer

How do I replace the wiper switch on a 2007 Suzuki Forenza?

Attached is a repair guide for all things wiper on this make and model and year. Wiper switch replacement is near the bottom of the web page. Also the tabs they say to depress to replace switch are in the picture of the switch below. Repair Guides Wipers Washers Windshield Wiper Systems AutoZone com 1s7098-5rxtnqb5gc5nqc33nsh0sc2r-1-0.jpg
3/30/2017 6:56:18 PM • 2007 Suzuki... • 629 views • 0 helpful votes
0helpful
1answer

What the 2007 suzuki forenza knock sensor location?

answered vast times ever like SEARCH. J20a or J20b engines. onside of engine block if present at all, the most new j20s do have one.
2/8/2017 4:53:35 AM • 2007 Suzuki... • 242 views • 0 helpful votes
0helpful
2answers

How do we reset a radio in my 2007 suzuki forenza

To reset the radio just disconnect the battery for a few minutes, if you require a security code contact this link: Car radio code in Uxbridge London Gumtree
11/1/2016 9:43:16 PM • 2007 Suzuki... • 267 views • 0 helpful votes
0helpful
2answers

I am leaking coolant from the crossover tube gasket. I have replaced the gasket and it is still leaking from the same spot. The leak is where the o ring sits in the gasket???

Did you examine the sealing surface for corrosion and pitting?? That is likely why it is leaking. You can try adding some RTV sealant to the O ring, that will fill the pits and most likely seal it up.
11/29/2016 7:31:56 PM • 2007 Suzuki... • 81 views • 0 helpful votes
0helpful
1answer

I've installed a new ..used trans in a 07 forenza I left torque converter empty knowing it would fill in initial start andvfill ....now im not so sure is there acway to fill and insure filling of torq

if you put the fluid in then when started it should fill the converter, i always when filling the trans i put 3or 4 quarts in then I put it through the gears and back in park and recheck untill full i do this untill it's full you might try it to see if it works for you
12/8/2016 9:27:31 PM • 2007 Suzuki... • 57 views • 0 helpful votes
0helpful
1answer

It is a 2007 Suzuki Forenza

This is for questions, that was a comment.
11/29/2016 7:36:04 PM • 2007 Suzuki... • 28 views • 0 helpful votes
0helpful
1answer

How to do timing for 2007 Suzuki forenza

timing of what , add one noun? spark cam what engine. of the 5 opted day 1. why pray tell say the job first, then ask a question. the clock in dash time? or the radio time or NAV or GPS, or????
8/23/2016 6:44:20 PM • 2007 Suzuki... • 129 views • 0 helpful votes
0helpful
2answers

What is head bolt torque and tightening sequence?

the USA 2.0L engine, key words, country and engine size. the 1million post with guy working an engine can say what is there. amazes me. .that.... its been posted on fixya before , the 2.0L engine. did you search, answer , no.... and want both, but failed to ask it bolts are 1: REUSABLE 2: OR TTY That is first on all modern engines. as is do i use degree';s or torque on this engine?> do so on all engines. why not use the FSM book from suzuki and read. like we do, we look read and know. in 5mins work. $4 read https://suzukipitstopplus.com/Products/1068-2007-forenza-reno-service-manual.aspx so ill login to my carppy online clone of above and say what's there. why ask for internet rumors on car engine rebuilding what if the rumor was WRONG.? that work for you>? no my rumors.. usa cars 2.0L and these words, step 1. "Cylinder head bolts. Tighten the cylinder head bolts gradually and in the sequence shown. Tighten the cylinder head bolts to 18 ft. lbs. (25 Nm) and turn the bolts another 3 turns of 90 degrees using the angular torque gauge KM-470-B." again, our USA 2.0L engine only, it does not state new bolts. 26024610-hkt52gi400f4we1nv5hxgewe-2-0.jpg end rumor off clone, FSM site , USA>.... YMMV.... your motor may vary.
12/27/2015 2:33:47 PM • 2007 Suzuki... • 1,336 views • 0 helpful votes
0helpful
1answer

How to reset anti theft security on 2007 Suzuki forenza please thanks

why double post? backup one and read. please.
6/9/2015 7:20:21 AM • 2007 Suzuki... • 1,280 views • 0 helpful votes
0helpful
2answers

My 2007 Suzuki forenza will turn over good but will not start fuel pump new but when you turn switch on can't hear it hum gas getting to injectors reckon it could be anti theft security please thanks

Is there a SECURITY light lit on the dash ? All anti-theft systems warn you some how if a problem is present ! The fuel pump only comes on for two seconds with key on ! When cranking the engine over if a crank pulse is see by the engine computer it will energize the relay turning on the fuel pump ! You have to check the fuel pump electrical circuit from the fuel pump relay !
6/9/2015 7:34:35 AM • 2007 Suzuki... • 1,241 views • 0 helpful votes
0helpful
1answer

Where is the fuel filter on 2007 Suzuki forenza I know the pump is underneath seat but I can't find the filter please thanks

on USA cars, the EPA made the engineers move it to the tank. if not found, guess where it is,,, it can only be 2 places. the line engine to tank or in the tank. they did this to reduce fuel heating... (no kidding) there are like 1million posts world wide asking this question. besides, Gas cap loose DTC codes. and how to reset oil change nag.... you could just RTM https://suzukipitstopplus.com/Products/1068-2007-forenza-reno-service-manual.aspx $4 to see it all, every part, every test, and procedure.
6/9/2015 7:41:06 AM • 2007 Suzuki... • 1,049 views • 0 helpful votes
0helpful
1answer

Could someone tell me how to reset anti theft security on 2007 Suzuki forenza please thank you very much

what are the symptoms?surely we can start there.1radio 2 anti theft securitycar alaram 3 anti theft securityengine 3 aka immoboilzer.if it's the IMMO, use the other key fob, that came with car new.never run just one key or you will be stranded.all 3 reset, when you key on the ignition.all 3.unless the battery is dead. does car run
6/9/2015 8:02:36 AM • 2007 Suzuki... • 451 views • 0 helpful votes
0helpful
1answer

On 2007 suzuki forenza tire pressure check engine and air bag lights are on had it checked nothing wrong so what do i do

check fuse first. as always , forever and ever.......... you need to scan it. the scan tool will tell you which TPMS sensor is bad. or take car to an tire store (yes, any) and the walk out with a hand scanner, pressed to each stim, and BINGO hey buddy, this ones .like DEAD. air bags is another issues, it too must be PCM scanned.
4/27/2015 9:21:53 AM • 2007 Suzuki... • 640 views • 0 helpful votes
Not finding what you are looking for?
2007 Suzuki Forenza Logo

75 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...