20 Most Recent 2004 Proton Gen-2 - Page 2 Questions & Answers

Need to be connected to a scanner and get it reset.

Proton Gen2 Cars... | Answered on Jun 13, 2014

How to remove Proton Gen 2 Fuel pump

Remove rear passenger bottom seat. Find a round metal cover on the v=center of the floor.Pry it open. You will see the pump. Remove the wire connector and the fuel pipes from the pump. Unscrew the big plastic retaining ring and pull the pump cannister up.

Proton Gen2 Cars... | Answered on Jun 13, 2014

1 Answer

Car has ingine problems itis getting hot or overheted

Check to see if radiator fan goes on when temp is about halfway on the temp gauge. If NOt running, check fuse and relay.If OK, check Coolant Temperature Sensor with scanner. Check the thermostat valve. Check water pump. Check clogged radiator.

Proton Gen2 Cars... | Answered on Jun 13, 2014

1 Answer

How to change key battery

you may have dropped the RFID chip inside the battery housing. That chip is used by the immobilizer to recognize the key. Get your spare key and use it to start. If you don't have one, you will need to get your key replaced and reprogrammed.

Proton Gen2 Cars... | Answered on Jun 13, 2014

1 Answer

Greater road clearence

There are rubber spacers available that can be used to raise ride height.

Proton Gen2 Cars... | Answered on Jun 13, 2014

1 Answer

Immobilzer problem proton gen2

The ignition key holds a sort of RFID chip. If you open it to change remote control battery or you dropped it to pieces and the chip comes off, you will not be able to start your car. Get your spare key and use it to start. The key that cannot be used to start has to be replaced/reprogrammed.

Proton Gen2 Cars... | Answered on Jun 12, 2014

0 Answers

2006 proton savvy passenger window won't go down. Goes up but not down but if you switch drivers side control switch over it will go down not up..

That shows the window motor and wiring are good leaving one of the switches. There should be battery and ground at both switch connectors check to make sure, check switches, find the battery terminal on the switch use a test light to check the other 2 terminals as you move the switch it should light in both directions, Now locate the ground wire it has to be the other (middle) wire by connecting the ground clip on the test light to the positive wire you just checked, then check the ground side of the switch the same way as the battery side. Think of a domino with 6 dots one middle dot is battery and the other middle dot is ground when the switch is moved the upper or lower outside dots get battery and ground at the same time when the switch is moved the other direction the other outside dots get the power and ground. I hope this helps. Take care.

Proton Cars &... | Answered on Aug 29, 2020

1 Answer

Proton Gen2 1.6 S4PH engine Cylinder Head Torque Settings. Cam Timing Marks Existing marks not clear When I aligned the marks prior to remove cylinder head the piston was half way up the sleeve not t

Good evening can someone please assist me with torque settings for a proton neo 1.6 2007 gen 2 thanks in advance

Proton Cars &... | Answered on Jul 02, 2020

1 Answer

Can't get to fuse box in my proton jumbuck 2004. Seems to be a grill over it. Help

Is this the one under the hood or the one inside the car? The one under the hood is next to the battery and has a simple 'clip on' black cover. The inside one will have a 'clip off' cover on the lower half of the dashboard. If there is a grille you might be trying to access it from the wrong position.

Proton Cars &... | Answered on Mar 08, 2020

1 Answer