20 Most Recent 2007 Pontiac Torrent Questions & Answers


Even if the C/E light went off before u scanned it, it should still have a code in its memory if an electronic problem was involved. have the emissions read, look for a lean condition, ck for over adjusted brakes (too tight)

2007 Pontiac... • Answered on Mar 06, 2021


There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few reliable-store for eg. .. let me know if u need help thanks

2007 Pontiac... • Answered on Feb 25, 2019


Air lock in the engine cooling system, likely from a bad water pump or other small leak allowing air into the system. Look for wet spot at bottom of water pump an indicator it is bad. Open radiator cap or reservoir and pump the hoses by hand to remove the air by squeezing it out rapidly or rev the engine up and down to assist air out of system with the caps off the reservoir or radiator. keep filling it up until there is heat and it doesnt flow out of the rad.

2007 Pontiac... • Answered on Dec 17, 2017


More than likely it is in the turn signal switch in the column.

2007 Pontiac... • Answered on Jun 03, 2017


High resistance in the circuit wiring ! Do you know how to do automotive electrical testing , voltage drop testing ? How to use a wiring diagram , how to use a DVOM - digital volt ohm meter ? Testing is the way to find electrical problems ! Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia Electric Testing Techniques You Need to Know http://www.bbbind.com/free_tsb.html free wiring diagrams .

2007 Pontiac... • Answered on Mar 24, 2017


It's probably the washer pump motor , but testing is the best thing to do . Fuse #45 front an rear washer pump , plus there is two relay's . Both are controlled by the BCM - body control module . The fuse is located in the under hood fuse box .

2007 Pontiac... • Answered on Feb 20, 2017


That's it in the pic? Kind of hard to gauge the bolt size from the picture. It must be metric, though. My guess, it looks like a 17 mm socket or wrench would fit. 15, 17, 18, or 19 mm, those are probably the choices. Don't you or a friend have wrenches or sockets that you could try?

2007 Pontiac... • Answered on Dec 06, 2016


Isn't it a steering column cover? These are usually or almost always held with screws that are recessed in deep holes in the cover. Look from underneath at the steering column. See the holes in the cover? Try a phillips head screwdriver to begin with. Sometimes the screws are torx head screws, sometimes just regular hex head screws that need a small socket over them. If there are no screws, then the cover will just pop off.

2007 Pontiac... • Answered on Dec 06, 2016


Setting the Time (Without Date Display) If your vehicle has an AM/FM base radio with a single CD player and preset buttons numbered one through six, the radio will have a clock button for setting the time. You can set the time by following these steps: 1. Press the clock button until the hour numbers begin flashing on the display. Press the clock button a second time and the minute numbers will begin flashing on the display. 2. While either the hour or the minute numbers are flashing, turn the tune knob, located on the upper right side of the radio, clockwise or counterclockwise to increase or decrease the time. Instead of using the tune knob, you can also press the SEEK, FWD (forward), or REV (reverse) buttons to adjust the time. 3. Press the clock button again until the clock display stops flashing to set the currently displayed time; otherwise, the flashing will stop after five seconds and the current time displayed will be automatically set. To change the time default setting from 12 hour to 24 hour, press the clock button and then the pushbutton located under the forward arrow label. Once the time 12H and 24H are displayed, press the pushbutton located under the desired option to select the default. Press the clock button again to apply the selected default, or let the screen time out. Setting the Time (With Date Display) If your vehicle has a radio with a single CD player or a CD with DVD player, the radio will have a clock button for setting the time and date. To set the time and date, follow these instructions: 1. Turn the radio on. 2. Press the clock button and the HR, MIN, MM, DD, YYYY (hour, minute, month, day, and year) will appear on the display. 220 3. Press the pushbutton located under any one of the labels that you want to change. Every time the pushbutton is pressed again, the time or the date if selected, will increase by one. • Another way to increase the time or date, is to press the right SEEK arrow or FWD (forward) button. • To decrease, press the left SEEK arrow or REV (reverse) button. You can also turn the tune knob, located on the upper right side of the radio, to adjust the selected setting. The date will not automatically display. The only way to see the date is by pressing the clock button when the radio is on. The date with display will time out after a few seconds and go back to the normal radio and time display. If your vehicle has a radio with a six-disc CD player, the radio will have a MENU button instead of the clock button to set the time and date. To set the time and date, follow these instructions: 1. Turn the radio on. 2. Press the MENU button. Once the clock option is displayed. 3. Press the pushbutton located under that label. The HR, MIN, MM, DD, YYYY will appear on the display. 4. Press the pushbutton located under any one of the labels that you want to change. Every time the pushbutton is pressed again, the time or the date if selected, will increase by one. • Another way to increase the time or date, is to press the right SEEK arrow or FWD (forward) button. • To decrease, press the left SEEK arrow or REV (reverse) button. You can also turn the tune knob, located on the upper right side of the radio, to adjust the selected setting. The date will not automatically display. The only way to see the date is by pressing the MENU button and then the clock button when the radio is on. The date with display will time out after a few seconds and go back to the normal radio and time display. 221 To change the time default setting from 12 hour to 24 hour or to change the date default setting from month/day/year to day/month/year, follow these instructions: 1. Press the clock button and then the pushbutton located under the forward arrow label. Once the time 12H and 24H, and the date MM/DD/YYYY (month, day, and year) and DD/MM/YYYY (day, month, and year) are displayed. 2. Press the pushbutton located under the desired option. 3. Press the clock or MENU button again to apply the selected default, or let the screen time out

2007 Pontiac... • Answered on Nov 10, 2016

Not finding what you are looking for?
2007 Pontiac Torrent Logo

75 questions posted

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14869 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Torrent Pontiac

  • Torrent Pontiac

Most Popular Question

2007 pontiac torrent wiper fluid will

  • Cars & Trucks
Loading...