20 Most Recent
2010 Peugeot 206 SW - Page 9 Questions & Answers
How to put lower baljoint back into lower leg
lower ball joints are fitted from the bottom up and are either bolted back in place or are pressed in place . I have done this pressing bit by fitting the ball joint in place and doing everything up and then placing a jack under the ball joint and raising the car so that the weight is on the suspension and ball and then I use a heavy hammer and hit the arm down which generally drives the ball joint into place.. Remember that the weight of the vehicle makes the suspension arm press down on the ball joint so it and tries to pull it up through the arm
Loosing power
Think you have a problem with the wiring connections but where ?? i couldnt tell you without a good look myself i would advise you ask a local mechanic to have a look for you
Heater circuit
check the fuse if good then check heater resistor pack if falty replace
Heater wont work climate control model
hi gary ther is a resistor pack that feeds the motor take note of the colours of the wires and the size of the wires that feed the motor and follow them back to the resister block and replace the resister block hope this will be helpfull
Not finding what you are looking for?