2004 Peugeot 206 SW - Page 8 - Answered Questions & Fixed issues
Peugoet 206 cc roof beeping
Put a resistor across the connector leads of the old motor. Something about 1 Watt and about 20 Ohms. This should remedy it- it will look like a motor winding to the onboard diagnostic computer.
How do I change the radiator in a peugeot 206 verve?
Pug 406 radiator change -drain the coolantremove top and bottom hose clips and the thin hose remove sensor multi plugremove hosesflick up clips at top of radlift it out!! that's it !!replace in reverse order making sure the bottom locating pin rubber grommets are in place.Hope this helps youKind regards
CAR WONT START
Sounds like a faulty starter solenoid or bad starter.Take a hammer and tap on the center of the starter housing while someone else tries to start it.If it starts then its your starters bendix that is bad in the starter. Make sure your wheels are chocked.
How do i replace the rear wheel bearing on my peugeot 206
wheel off remove the tin cap in the centure of the hub undo the big nut put the wheel back on with just 2 bolts finger tight so you can pull the hub off.once the hub is off take the 2 wheel bolts back out.now look in side the hub were the big nut was and you will see a sir clip take that out.then use a socket and a bench vice to press the old bearing out.use the socket and bench vice to put the new bearing back in.
Peugeot 207cc crackling noise coming from black box under windscreen grille
The rattling sound from the device under the grille on the windshield of your Peugeot 207cc may be caused by a loose wire or a broken part in the electrical system. It's crucial to fix this problem right away to avoid any further damage to the car. It's best to take it to a Peugeot dealership for a checkup and diagnosis. Ignoring this could lead to bigger issues later on.
MY PEUGEOT 2001 ELYSOE 125CC WONT START IF ITS COLD
Do you mean cold weather? When was the engine last serviced? Old, dirty spark plugs and old, dirty filters can cause bigger problems than you would expect.
On really cold days try to 'Prime' the engine. My method is to use the kick start to spin the engine over 3 or 4 times before using the electric button start. If yours has a manual choke try gradually sliding it down to a lower setting once it is idling and all the way off once you are riding.
Not finding what you are looking for?