20 Most Recent 2010 Nissan Versa 1.8 Questions & Answers

Here is the definition. You may need to have someone check the accelerator pedal position sensor and the circuit.

P2138 NISSAN Description The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM).
Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM.
In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals.
Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation
such as fuel cut.
Read more: http://engine-codes.com/p2138_nissan.html#ixzz26J3D2x8s

2010 Nissan... | Answered on Mar 02, 2015

Fuel inertia switch stops the fuel pump running in the case of a collision causing a broken fuel pipe which otherwise could spray a litre of petrol every few seconds and rather spoil someone's day.

Certainly a tripped inertia switch would prevent the engine from starting but I doubt it would stop the engine cranking, though I don't have up to date information on the model and there could be different safety regulations where you are.
The inertia switches are accessible and resettable so why not just reset it and try again. Your vehicle handbook will have the details.

An immobiliser stops the the engine cranking on some vehicles as well as stopping the spark and injection and often the fuel pump.
Bridging the battery positive wire to the solenoid to make the starter crank the engine won't be switching the rest of the stuff back on.

2010 Nissan... | Answered on Feb 06, 2015

The dipstick is located in the hardest to reach spot. On the drivers side, under the battery, under a pipe or two you have to find a black dot, that dot is the dipstick. There is no ring or hook to grab it by so pull the black dot out and you'll see that it is about 2 inches long, the 'dipstick' itself is about the size of a thumbnail. We had to use two funnels slid together to be able to put the fluid into that hole. Then dropped the dipstick while trying to put it back in, multiple times. This was the most extremely frustrating routine maintenance I've ever done. I understand now why so many Nissan Versas have transmission problems, no one can maintain them properly. I've attached a photo of what the dipstick actually looks like.

Nissan Versa... | Answered on Dec 18, 2019

Disconnect the fan and try jumper wires to the fan from the battery to the fan to see if it works. Also inspect both connectors.

Nissan Versa... | Answered on Apr 26, 2019

That is not easily done since these modern cars have large integrated plastic shells with the reflectors and lamps. The mounting points might have an adjustment, but if you do it wrong, you might break something. That could be very expensive. Gone are the days of metal brackets and screws holding heavy glass lamps that are almost indestructible.
There are specialized headlight aiming machines for many models that will let a technician accurately adjust your Nissan. Contact the dealer to see if they do it, or can refer you.

Nissan Versa... | Answered on Apr 02, 2019

Suggest you take it to a qualified repair shop an have it checked out . Brake booster wouldn't have anything to do with it jamming . Maybe ABS system problem.

Nissan Versa... | Answered on Mar 07, 2019


Nissan Versa... | Answered on Jan 10, 2019

The best solution you'll get from books at www.reliable-store.com

These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc

Nissan Versa... | Answered on Jun 15, 2018

test for power at the blower connector

Nissan Versa... | Answered on Jun 02, 2018

P1610 NISSAN - Lock Mode

P1610 NISSAN - Lock Mode

Read more: https://www.autocodes.com/p1610_nissan.html
Read more: https://www.autocodes.com/p1610_nissan.html

Nissan Versa... | Answered on May 16, 2018

Most four cylinders, the firing order is 1 3 4 2.

Nissan Versa... | Answered on Apr 17, 2018

press the brake (automatic)hard or,(stickshift) press the clutch pedal down to the floor and hold it then shift into neutral and, attempt to start the car

Nissan Versa... | Answered on Mar 17, 2018

Not finding what you are looking for?
2010 Nissan Versa 1.8 Logo

Popular Tags

3 questions posted

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Versa Nissan

  • Versa Nissan

Most Popular Question

2010 nissan versa got in collision wont

  • Cars & Trucks