20 Most Recent
2006 Nissan Maxima SL Questions & Answers
2006 nissan maxima SL slip light on what's that mean?
The slip light illuminates when a traction control component fails or sends incorrect info to ecm. Normally problem is at wheel speed sensor, DO NOT REPLACE SENSOR UNLESS PROPERLY DIAGNOSED AS DEFECTIVE. FIRST all reason normally is due to gathering of debris at sensor , I would raise front wheels and support vehicle with jack stands (SAFETY FIRST) Remove wheels and locate wheel sensor and clean as needed. and see if this corrects problem. if problem still persist. then check for stored dtcs and start from there
I’m happy to assist further over the phone at
https://www.6ya.com/expert/james_9ddabbbc483e2add
Maxima problems
Sounds like you have a wheel bearing going out. Try swerving car left to rt on a straight road with NO traffic. If the noise is louder one way and less or gone the other it's a wheel bearing
Horn wont blow
start by checking your fuse. if its not blown, then make sure you have power going to the horn when horn is engaged. If you have power, then horn is blown, time for a new one.
4 cds stuck and want reject out
Your going to have to pull the unit and reove the top lid to get them out, Just be very careful not to breck anything inside the unit (CD player)
Obd code p0420
That is a Catalitic Converter Code remove it from your car and let it Soak in in a bucket of water w/dish washing detergent over night then let it dry completely clear the code and reinstall it, that should clean the junk out of it. If the code code comes back on then you'll have to install a new one! Hope it works, cause they arent cheap... Good Luck...
Jumping rpms and car starting in 5th gear
HelloThe engine
and automatic transmission in this vehicles drive train
are fully electronically controlled by a computer called the PCM
(Power Train Control Module). Whenever a problem like this occurs the
computer stores a record of the problem (there are of course some
exceptions to this, like the fuel pump, engine coolant temperature
sensor and MAF sensor for instance) in the form of a fault code in
its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A
TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR
HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
1995 3.0 engine. Where is the crankshaft (position) sensor?
In the 1995 Nissan X-Trail with a 3.0-liter engine, the crankshaft position sensor is typically located on the engine block. However, it's important to note that the 1995 X-Trail model was not available with a 3.0-liter engine. It's possible that you may be referring to a different Nissan model or engine.
To provide you with accurate information, please specify the correct Nissan model and engine.
Power locks fell into door
Remove door panel by prying out at the bottom. Follow around door and remove the panel retainering tabs. Push up on panel to remove from top of door. Now snap the window lock button assembly back in place.
How to fix 00 maxima
00 maximas don't have swirl control valves that feature wasn't added until 01 unless by some wierd chance your max was made after July in 00 and is cal spec
Not finding what you are looking for?