20 Most Recent
2007 Mitsubishi Outlander 2.4 Questions & Answers
What is the cylinder head bolt torque settings fir a 4g69 mitsubishi engine ?
BOLT INSTALLATION
Apply engine oil to the thread of the bolts and to the washers.
Tighten the bolts to the specified torque, using the tightening sequence shown.
Tightening torque: 54 ft-lb +/- 2 ft-lb
Loosen all bolts fully in the reverse order of tightening.
Re-tighten the loosened bolts to the specified torque in the tightening sequence shown.
Tightening torque: 15 ft-lb +/- 1 ft-lb
This step is to make it easier to ensure you are making 90 degree turns. Make a paint mark across each bolt head and cylinder head.
Tighten the cylinder head bolts 90 degrees in the specified order.
Tighten the bolts another 90 degrees in the specified order and check that the paint marks on the cylinder head bolts are aligned with the paint marks on the cylinder head.
Link to the guide for this engine: http://www.mivec.co.nz/tech/4G9x_Engine_Manual.pdf
Need to find wiring to and from fuel sending unit in2008 outlander
Hope this helps, the color code is at the bottom. I looked up your year--make--model in my database, 2.4L engine. At the main fuel level sensor at the bottom, the top wire should be voltage, the bottom black wire is ground. I did see a couple trouble codes for fuel level sensor, one was a po code, the other was manufacturer specific code. I know nothing about this vehicle other than what my database shows. good luck
Where is the Crankshaft sensor on a Mitsubishi outlander 07 es 3.0l v6 and how do I get to it
If you know anything about gasoline engines at all, I can tell you that the Crankshaft sensor is what replaced the distributor and cap on the engine. You find where the distributor would have been ad that's where the sensor now is. On the top of the distributor shaft. It's easy to get to and no problem to change, it's just a LOT more expensive than the old stuff. Typically only a couple of screws hold it down and you can't screw it up when you use the stuff that comes with the new sensor. Instructions come with it in a kit.
Remove door panel 2007 outlander
I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic o r fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years
Not finding what you are looking for?