1984 Mazda 323 - Answered Questions & Fixed issues

It helps to have a year, and also the part for the torque settings.In the linkhttps://www.google.com/search?q=Mazda+323+b3+torque+settingsYou are my 65,000th Answer on Fixya!!..

Question edited for clarity. Question moved to model category. Bad seals, damaged float needle, or dirt in there. https://www.google.com/search?q=Mazda+323+1.3+Midge+adjust+carb+float ..

Question edited for clarity. Question moved to sub category. Some are supposedly lifelong use! The normal way is to drain the ATF and measure it. You repace with the same amount. Overfilling causes problems. https://cararac.com/gear_oil/mazda/323.html Videos https://www.google.com/search?q=2000+Mazda+323+replace+automatic+transmission+fluid ..

Question edited to add maker. Question moved to sub category. Will be similar to the ones in the videos. https://www.google.com/search?q=Mazda+Familia+323+replace+clutch ..

323 (BF), 1600 F6
Valve clearance - inlet: 0.30 h mm (hot)
Valve clearance - exhaust: 0.30 h mm (hot)
Compression pressure: 14.5 bar

hope this helps.

Check the owners manual. If you need one, try ManualsLib Makes it easy to find manuals online

Please send me the diagram showing the marks especially on the top .

for heavy machinery cars etc. luckily there are many websites that can help you repair for eg site like reliable-store is very active in this.. instant help, emails and all that's fantastic

Intake 0.15 - 0.20
Exh 0.20 - 0.25

You will get your solution and all info on service info, repair info, parts info, wiring/electrical/ fuse diagrams, error/fault codes, torque specs, PCV, owner's/service/repair/parts/maintenance manuals etc everything this website www.reliable-store.com it's a very good website for vehicle problems even as old as 1991 ford..

That's a major transmission problem. Internal issue with shifting valve.

A cheap shop manual will give you all this and more!

It also warns of low brake fluid check it

Hard to give you ideas on what the problem is without checking to see what the codes are in the airbag control module.

Air in lines or bad master cylinder

There is an adjuster on the AC belt or perhaps the compressor can be loosened and moved a tad to remove the ac belt.

Write your answer...Thank you so much for the tque sets. Ive been worried abt where to get them

No, there should not be oil allowed around the cam or timing belt. Oil is bad for those belts.

idle control sensor or fuel delivery problem correct part depends on what year it was built e 10 not the best fuel for older 121s you may have to replace the fuel filter this site may help a bit ...have to keep flipping pages to get to sections

MAZDA 121 WORKSHOP MANUAL Pdf Download. - ManualsLib

https://www.manualslib.com > Brands > Mazda Manuals > Automobile > 121

That's some of the symptoms also TPS , vacuum leak